Abstract:A copolymer P(MEO(2)MA(m)co-OEGMA(n))-b-PDPA(p) (poly[di(ethylene glycol) methyl ether methacrylate-co-oligo(ethylene glycol) methacrylate]-b-poly[2-(diisopropylamino) ethyl methacrylate]) had been designed to have good stimuli-response for developing temperature/pH dual-responsive drug delivery systems. In this study, the copolymer was synthesized in two steps: atom transfer radical polymerization (ATRP) method, followed by the continuous ATRP method for P(MEO(2)MA(m)-co-OEGMA(n)) and P(MEO(2)MA(m)-co-OEGMA(n))b-PDPA(p), respectively. The data of proton nuclear magnetic resonance spectroscopy (H-1 NMR) and gel permeation chromatography (GPC) showed that the chemical compositions of the two copolymers could be precisely controlled. The aqueous solution properties of the copolymers were investigated using a UV-visible spectrophotometer. Results showed that the former random copolymers had reversible temperature response, while the end product exhibited temperature/pH dual-responsive behaviors. Their lower critical solution temperatures (LCSTs) were found to be dependent on the ratios of the monomers. Firstly, the relationship between the monomer ratio and the low critical solution temperature (LOST) of P(MEO(2)MA(m)co-OEGMA(n)) was investigated. It was found that within the range of the experimental study (m + n = 100, 0 < n < 30), the LOST of the copolymer showed a linear relationship with the number of OEGMA units in each polymer chain. Then, the proportion of the two monomers (MEO(2)MA(m) and OEGMA) was fixed (m = 90, n = 10) and the random terpolymer P(MEO(2)MA(m)-coOEGMA(n))-b-PDPAp was synthesized. The LCSTs of P(MEO(2)MA(m)-co-OEGMA(n))-b-PDPAp were found to be highly dependent on the DPA unit numbers in the range of 15 < p < 30 while their pH trigger points were not related to the chemical composition of the P(MEO(2)MA(m)-co-OEGMA(n))-b-PDPAp. Finally, the copolymer P(MEO(2)MA(90)-co-OEGMA(10))-b-PDPA(22) with a LOST of 43 degrees C and a pH trigger point of 6.5 was carefully selected for preparing micelles, as a nanocarrier of doxorubicin (DOX) for an in vitro release study. The in vitro release kinetics of copolymer micelles were studied under different conditions. At pH 7.4, which mimics the normal physiological condition, the total release amount of DOX at 37 degrees C was about 25%, which was much higher than that at a higher temperature of 45 degrees C (approximately 5%). However, at pH 5.0, which mimics the intracellular environment, the cumulative release of the DOX quickly reached 95% at 37 degrees C, while the cumulative release of the drug at 45 degrees C was only about 65% in the same period of time. For the latter, a slow and sustained release was observed and the cumulative drug release amount reached about 85% in 30 h. These results showed that the environmental stimuli response of the copolymer determined the drug release behavior of the micelles. This copolymer-based drug carrier could be expected to undergo bursting and sustained drug release in response to different conditions. Therefore, the results show potential for applications in the design and preparation of controllable drug transportation systems.

Synthesis and characterization of poly(Maltodextrin) microgel from maltodextrin as drug delivery system

Degradable and Thermosensitive Microgels Synthesized Via Simultaneous Quaternization and Siloxane Condensation

Development and evaluation of stimulus-sensitive microgels for controlled drug delivery

Synthesis and In Vitro Evaluation of Aspartic Acid Based Microgels for Sustained Drug Delivery

Synthesis of amphiphilic alternating polyesters with oligo(ethylene glycol) side chains and potential use for sustained release drug delivery.

Effects of the multilayer structures on Exenatide release and bioactivity in microsphere/thermosensitive hydrogel system

Exenatide-loaded microsphere/thermosensitive hydrogel long-acting delivery system with high drug bioactivity

Fabrication and evaluation of cross-linked nanogels of Dexibuprofen

Innovative Microencapsulation of Polymyxin B for Enhanced Antimicrobial Efficacy via Coated Spray Drying

Hydrolyzed polyacrylamide grafted maize starch based microbeads: Application in pH responsive drug delivery

Natural polymeric microspheres for modulated drug delivery

Shell-crosslinked micelles with neighborhood effect and pH/GSH sensitivity for co-loading of protein and polyphenol drugs

Drug release from the enzyme-degradable and pH-sensitive hydrogel composed of glycidyl methacrylate dextran and poly(acrylic acid)

Novel chitosan and N-isopropylacrylamide-grafted-dextran-based microformulations as effective oral drug delivery system

Poly(vinylcaprolactam)-Based Biodegradable Multiresponsive Microgels for Drug Delivery

Sustained release drug delivery using supramolecular hydrogels of the triblock copolymer PCL–PEG–PCL and α-cyclodextrin

Synthesis and characterization of arabinoxylan-bis[2-(methacryloyloxy)ethyl] phosphate crosslinked copolymer network by high energy gamma radiation for use in controlled drug delivery applications

The Preparation of Methoxypolyethylene Glycol-Poly(β-benzyl Malate) of Loading-drug Micelle and Determination of Characteristics

Design and Synthesis of Multi-Responsive Copolymers for Drug Carrier

Development and evaluation of a pH-responsive Mimosa pudica seed mucilage/β- cyclodextrin-co-poly(methacrylate) hydrogel for controlled drug delivery: In vitro and in vivo assessment

Gellan Gum/Alginate Microparticles as Drug Delivery Vehicles: DOE Production Optimization and Drug Delivery