Abstract:In the development of advanced steel, accurate and detailed knowledge about the kinetics of phase transformations and microstructure formation is critical. The critical issue in pearlite-austenite transformation is the consideration of diffusional paths of the alloy element. Simulation has been an available method to study the diffusion of alloy elements and the migration rate of the phase boundary in the complex morphological evolution of austenite growth. The isothermal pearlite-austenite transformations at 720 and 740 degrees C in Fe-0.6%C-2%Mn (mass fraction) alloy were studied by phase-field methods based on MICRESS. At different temperatures, the effects of diffusional paths on the austenite transformation were discussed. To achieve a semiquantitative verification of the simulated results, the migration rates of the austenite/pearlite boundary at 720 and 740 degrees C were estimated from the experimental kinetics curves by fitting the JMA equation. By measuring the Mn profile in austenite, the modes of the austenization at 720 and 740 degrees C can be verified as partitioned local equilibrium (PLE) and non-partitioned local equilibrium (NPLE) modes. The heterogeneous distribution of Mn in austenite at 740 degrees C can be observed with STEM-EDS. However, the homogenous distribution of Mn can be found near the pearlite/austenite boundary in austenite at 720 degrees C. The cases considering the gamma, alpha, and interface-diffusional paths were simulated by phase-field methods to compare with the migration rates of the austenite/pearlite boundary. Because carbon is an interstitial element in steel and has an interstitial diffusional mechanism, it can be speculated reasonably that the diffusion of C mainly proceeded in austenite and ferrite through the considerations of the atom-size of carbon and the experimental results. Phase-field methods were used to study Mn diffusion in the lamellar pearlite-austenite transformation. With the analysis of the experimental estimations, the interface-diffusional path was observed as the dominant path for the Mn diffusion. It is because the Mn atoms have greater diffusivity in interfaces than in gamma or alpha-diffusional paths. Furthermore, the diffusional activation energy is closely related to the diffusivity of Mn at the interface. Moreover, compared with the gamma-diffusional path, the diffusional flux of Mn in ferrite is much larger than that in austenite. Thus, it can be concluded that the contribution of the alpha-diffusional path to the migration rate of the pearlite/austenite boundary is larger than that of the gamma-diffusional path. As a result, considering the alpha-diffusional path in the thermodynamics analysis under NPLE mode makes more sense. However, ignoring the interface- and alpha-diffusional path, which is different from the traditional cognition in PLE mode, will result in a magnitude error for the thermodynamics analysis.

Cascading phase transformations in situ for the simulated coarse-grained heat-affected zone of P92 heat-resistant steel

The austenite to polygonal ferrite transformation in low-alloy steel: multi-phase-field simulation

Multi-phase Field Simulation of Multi-Grain Peritectic Transition in Multiple Phase Transformation

Phase transformation and microstructure evolution of pearlite heat-resistant steel during heating

In Situ Observation of Phase Transformation and Structure Evolution of a 12 Pct Cr Ferritic Stainless Steel

Multi-phase-field simulation of D019-χ transformation in Co-Al-W superalloy with L12-γ′ + fcc-γ phases

Atom-probe tomographic and dilatometric studies of phase-transformations after inter-critical annealing of a low-carbon dual-phase steel

In Situ Observation of Martensitic Phase Transformation in Low Carbon Steel Containing Cu

Simulated Coarse Grain Heat‐Affected Zone Transformation Behavior of Newly Developed Zr–Ti–RE Deoxidized High‐Strength Low‐Alloy Steels with Extremely High Impact Toughness

Phase transformation from phase to S phase at grain boundary during annealing in rapidly-solidified Al-Zn-Mg-Cu alloy

In Situ Observation of Bainite to Austenite Transformation of Microalloyed High Strength Steel During Simulated Welding Cycle

In-situ Observation of Solid Phase Transformation of a low Carbon Steel

Phase Field Study of the Diffusional Paths in Pearlite-Austenite Transformation

In-situ Observation of Phase Transformation During Heat Treatment Process of High-Carbon Bainitic Bearing Steel

Microstructure Transformation on Pre-Quenched and Ultrafast-Tempered High-Strength Multiphase Steels

Phase transformation from η phase to S phase at grain boundary during annealing in rapidly-solidified Al-Zn-Mg-Cu alloy

Research on the Phase Transformation of a Newly Developed Carbonitride-Strengthened Martensitic Heat Resistant Steel

Phase-field Modeling of Cyclic Phase Transformations in Low-Carbon Steels

In situ observation of the austenite to ferrite transformation in low-carbon steels from different initial phases at defined cooling rates

On the role of chemical heterogeneity in phase transformations and mechanical behavior of flash annealed quenching & partitioning steels

In Situ Observation of Acicular Ferrite Formation and Grain Refinement in Simulated Heat Affected Zone of High Strength Low Alloy Steel