Abstract:This paper presents the results of a systematic comparative study of the dynamic thermomechanical response of Ti–6Al–4V alloys with three different microstructures. Two of the alloys are produced by the hot isostatically pressed technique using rapidly solidified granules, with one alloy milled prior to hot pressing. Experiments are performed over a broad range of strain rates, 10−3–7000s−1, and initial temperatures, 77–1000 K. Depending on the test temperature, compressive strains of 10–60% are achieved. The microstructure of the undeformed and deformed specimens is investigated, using optical microscopy. The dependence of the flow stress on the temperature and the strain rate is examined for various strains and it is related to the corresponding material microstructure. The results show that adiabatic shearbands develop at high strain rates, as well as at low strain rates and high temperatures. Depending on the test temperature, shearbands initiate once a sample is deformed to suitably large strains. The flow stress is more sensitive to temperature than to the strain rate. Based on these results and other published work, the thermally activated mechanisms associated with the dislocation motion are identified. The physically based model proposed by Nemat-Nasser and Li (1997) for OFHC copper, is suitably modified and applied to this class of titanium alloys. In the absence of dynamic strain aging, the model predictions are in good accord with the experimental results. Comparing the results for the three considered Ti–6Al–4V alloys, with different microstructures, it is found that the initial microstructural features affect only the magnitude of the threshold stress and the athermal part of the flow stress, but not the functional dependence of the thermally activated part of the flow stress on the temperature and the strain rate.

The yielding and plastic flow behavior of TC17 alloy under tension/compression-torsion loading at high strain rates

Dynamic Yielding and Plastic Flow Behavior of Ti-6al-4v under Complex Loading

Investigation on Plastic Flow Behaviors of FCC Polycrystalline Aluminum under Pre-Cyclic Tension-Compression Loading: Experiments and Crystal Plasticity Modeling.

Study on Dynamic Mechanical Response of TC21 Alloy

Anisotropy of Yielding/Hardening and Micro-Inhomogeneity of Deforming/Rotating for A Polycrystalline Metal under Cyclic Tension Compression

Dynamic plasticity of AZ31 magnesium alloy: Experimental investigation and constitutive modeling

Dynamic Response of Conventional and Hot Isostatically Pressed Ti–6Al–4V Alloys: Experiments and Modeling

Flow Behavior and Dynamic Transformation of Bimodal TC17 Titanium Alloy During High Strain Rate Hot Compression

Yield Surfaces and Plastic Flow of 45 Steel under Tension-Torsion Loading Paths

CRYSTAL PLASTICITY NUMERICAL ANALYSIS ON YIELD AND SUBSEQUENT YIELD OF POLYCRYS-TALLINE COPPER UNDER COMBINED TENSION--TORSION LOADING

Investigation of evolving yield surfaces of dual-phase steels

Flow Behavior and Dynamic Recrystallization Mechanism of 7050-T7451 Aluminum Alloy During Hot Deformation

Hot Deformation Behavior and Constitutive Model of TC18 Alloy During Compression

Study on Dynamic Compressive Mechanics Behavior of TC17 Titanium Alloy at High Temperature and High Strain Rates

Analysis On The Constitutive Relationship Of Tc18 Titanium Alloy Based On The Softening Mechanism

Characterization of Yield Surface Evolution of AZ31 from Shear to Equibiaxial Tension

Characterization and modelling of evolving plasticity behaviour up to fracture for FCC and BCC metals

Experimental study of macro-micro dynamic behaviors of 5A0X aluminum alloys in high velocity deformation

Dynamic Mechanical Properties of TC11 Titanium Alloys Fabricated by Wire Arc Additive Manufacturing

Deformation Behavior and Processing Maps During Isothermal Compression of TC21 Alloy

Experimental Research on Dynamic Mechanical Behavior of TC18 Titanium Alloy under Medium and High Strain Rates