Abstract:Abstract CO2 injection is regarded as an important method for enhanced oil recovery (EOR) and greenhouse gas control by storing CO2 underground. However, the reservoir heterogeneity and low viscosity of CO2 will result in poor sweep and therefore inadequate oil recovery and inefficient gas storage. The entanglement of biopolymers is a well-known phenomenon that, when controlled, can result in a smart fluid with strong gelation properties. We have shown that when a suitable salt is incorporated into the cellulose nanocrystal (CNC), the fluids undergo gelation upon contact with bulk phase CO2 but remain a flowing liquid otherwise. In this study, we applied this composition-selective trigger to improve the sweep efficiency in CO2 EOR and sequestration. Benchtop tests were performed to observe the gelation time and strength of gel to optimize the chemical concentrations accordingly. Parameters such as CNC and salt concentrations were optimized to tune the gelation time and gel strength. The optimized CNC fluid was tested for its ability to turn to gel within the porous medium as CO2 encounters the fluid. Flow tests were performed in a representative model porous media to analyze the in-situ gelation inferred from pressure profile and fluid production. CO2 and N2 gas were used as the gas phases. A heterogeneous dual-sandpack was used to demonstrate sweep efficiency improvement during CO2 injection. Tuning the chemical concentration enabled us to optimize the gel strength and more importantly gelation time across a wide range, from 5 minutes to more than 48 hours. The gel can be easily broken in contact with nitrogen gas. After CNC+salt fluid was placed in porous media initially containing water and CO2, subsequent injection of CO2 required a very large pressure gradient to initiate flow demonstrating the in-situ generations of gel. Once the flow was initiated, subsequent sequential injections of CO2 and N2 exhibited smaller resistance to N2 than to CO2, consistent with the reversible gel/solution transition in the presence/absence of CO2 observed in batch experiments. Flow tests in heterogeneous dual-sandpack (with permeability contrast of 5) revealed that in-situ gelation diverts injected CO2 almost entirely to the lower permeability layer, which had been almost completely bypassed during injection prior to the CNC+salt injection. The composition-specific trigger, the ability to control the fluid's properties, and the renewable source of nanomaterials will open up an enormous opportunity for CO2 injection processes in heterogeneous reservoirs, in challenging locations (i.e. offshore) and in related applications such as CO2 sequestration.

Underground CO 2 Flow Control: A Comparison of Gels, Foams, and Nanoparticles

CO2 Geostorage and Enhanced Oil Recovery: Challenges in Controlling Foam/Emulsion Generation and Propagation

Conformance control by a microgel in a multi-layered heterogeneous reservoir during CO2 enhanced oil recovery process

Gas channeling control with CO 2 -responsive gel system in fractured low-permeability reservoirs: Enhancing oil recovery during CO 2 flooding

CO2-triggered gelation for mobility control and channeling blocking during CO2 flooding processes

Aqueous CO 2 Foam Armored by Particulate Matter from Flue Gas for Mobility Control in Porous Media

Investigating the Potential of CO2 Nanobubble Systems for Enhanced Oil Recovery in Extra-Low-Permeability Reservoirs

Importance of conformance control in reinforcing synergy of CO 2 EOR and sequestration

Rheological properties and gas channeling plugging ability in CO2 flooding of a hydrophobic nanoparticle-enhanced smart gel system constructed with wormlike micelles

Nanoconfinement Effect on the Miscible Behaviors of CO2/shale Oil/surfactant Systems in Nanopores: Implications for CO2 Sequestration and Enhanced Oil Recovery

Review of Foam with Novel CO2-Soluble Surfactants for Improved Mobility Control in Tight Oil Reservoirs

Review Of Liquid Nano-Absorbents For Enhanced Co2 Capture

A novel dual-network CO 2 -responsive particle gel for mitigating CO 2 channeling and leakage in hydrocarbon recovery and carbon storage

A Review of Polymer Gel Utilization in Carbon Dioxide Flow Control at the Core and Field Scale

Performance and applicable limits of multi-stage gas channeling control system for CO2 flooding in ultra-low permeability reservoirs

Nanofluids and nanocomposite membranes for enhanced CO2 capture: A Comprehensive Review

Features of nanoparticle composite-enhanced CO2 foam-flooding systems for low-permeability reservoirs

Nanoparticle-reinforced foam system for enhanced oil recovery (EOR): Mechanistic review and perspective

Research Progress on CO2 Capture, Utilization, and Storage (CCUS) Based on Micro-Nano Fluidics Technology

Cellulose Nanocrystal Switchable Gel for Improving CO2 Sweep Efficiency in Enhanced Oil Recovery and Gas Storage

Surfactant and a mixture of surfactant and nanoparticles to stabilize CO2/brine foam, control gas mobility, and enhance oil recovery