Abstract:Although the force/pressure applied onto a textile substrate through a uniaxial compression is constant and independent of the yarn direction, it should be noted that such mechanical action causes a geometric change in the substrate, which can be identified by the reduction in its lateral thickness. Therefore, the objective of this study was to investigate the influence of the fabric orientation on both knitted and woven pressure sensors, in order to generate knowledge for a better design process during textile piezoresistive sensor development. For this purpose, these distinct textile structures were doped with different concentrations of graphene nanoplatelets (GNPs), using the screen-printing technique. The chemical and physical properties of these screen-printed fabrics were analysed using Field Emission Scanning Electron Microscopy, Ground State Diffuse Reflectance and Raman Spectroscopy. Samples were subjected to tests determining linear electrical surface resistance and piezoresistive behaviour. In the results, a higher presence of conductive material was found in woven structures. For the doped samples, the electrical resistance varied between 105 Ω and 101 Ω, for the GNPs' percentage increase. The lowest resistance value was observed for the woven fabric with 15% GNPs (3.67 ± 8.17 × 101 Ω). The samples showed different electrical behaviour according to the fabric orientation. Overall, greater sensitivity in the longitudinal direction and a lower coefficient of variation CV% of the measurement was identified in the transversal direction, coursewise for knitted and weftwise for woven fabrics. The woven fabric doped with 5% GNPs assembled in the weftwise direction was shown to be the most indicated for a piezoresistive sensor, due to its most uniform response and most accurate measure of mechanical stress.

Understanding the relationship between nanosheet thickness and piezoresistivity in graphene strain sensors

On the mechanism of piezoresistance in nanocrystalline graphite

Asymmetric Behavior in Flexible Piezoelectric Strain Sensors Made of Single Zno Nanowires

Proposal for a graphene based nano-electro-mechanical reference piezoresistor

Fundamental Insights into Graphene Strain Sensing

Strain-Correlated Piezoelectricity in Quasi-Two-Dimensional Zinc Oxide Nanosheets

Mechanical Properties of Small Quasi-Square Graphene Nanoflakes

Piezoresistivity and Strain-induced Band Gap Tuning in Atomically Thin MoS2

Using Electrical Impedance Spectroscopy to Separately Quantify the Effect of Strain on Nanosheet and Junction Resistance in Printed Nanosheet Networks

Superior Piezoresistive Strain Sensing Behaviors of Carbon Nanotubes in One-Dimensional Polymer Fiber Structure

Mechanisms Underlying the Shape Effect on Nano-Piezoelectricity

Frequency-Dependent Piezoresistive Effect in Top-down Fabricated Gold Nanoresistors

Comprehensive evaluation of the piezoresistive behavior of carbon nanotube-based composite strain sensors

Understanding the sensitivity of thin-film graphene/polymer nanocomposite strain sensors to ultrasonic waves: Analytical and experimental analysis

Elucidating Piezoelectricity and Strain in Monolayer MoS 2 at the Nanoscale Using Kelvin Probe Force Microscopy

Piezotronic effect in AlGaN/AlN/GaN heterojunction nanowires used as a flexible strain sensor

Development of Piezoresistive Sensors Based on Graphene Nanoplatelets Screen-Printed on Woven and Knitted Fabrics: Optimisation of Active Layer Formulation and Transversal/Longitudinal Textile Direction

Unidirectional Electron-Tunnelling Flexible PDMS Strain Sensor with Aligned Carbon Nanotubes

Size and Semiconducting Effects on the Piezoelectric Performances of ZnO Nanowires Grown onto Gravure-Printed Seed Layers on Flexible Substrates

Thickness-Dependent Piezoelectric Property from Quasi-Two-Dimensional Zinc Oxide Nanosheets with Unit Cell Resolution

Ultrahigh sensitive piezotronic strain sensors based on a ZnSnO 3 nanowire/microwire