Abstract:When smelting silicon manganese alloy in an industrial electric furnace, it will produce smoke and dust waste gas, which can be utilized again back to the furnace and improve the utilization rate of raw materials after a particular trapping device and collection treatment. However, at higher moisture levels, they are prone to explode. Effects of various initial masses, initial moisture contents, and microwave output powers on the soot ash of smelting silicon manganese alloy were studies. The findings indicate that the microwave drying rate increases with all three variables. The time for complete microwave drying is directly proportional to the sample's initial moisture content and the sample's initial mass, and the time for complete microwave drying is inversely proportional to the microwave output power. The results demonstrate that the Modified Page model can accurately describe the microwave drying process. The experimental data were fitted experimentally by drying kinetic models. Microscopic characterization of soot ash from refining silico‑manganese alloys before and after drying was carried out using FTIR and SEM. Through FTIR characterization, the peak value of the -OH absorption peak decreases upon drying, and SEM results in no agglomeration caused by microwave drying and better dispersion of the soot ash of the dried smelted silica‑manganese alloys, all of which proved that microwaves could effectively remove water. It was discovered that the diffusion coefficient increased gradually with increasing power when it was computed using Fick's second law. The diffusion coefficient increases and then decreases as the moisture content increases. The diffusion coefficient decreases as the initial mass increases. Activation energy of microwave drying of soot ash from the refining of silicomanganese alloys was calculated to be -1.4467 W/g. Its purpose is to offer a detailed guide for the industrial drying of soot ash from silicomanganese alloy refinement using microwave drying technology.

Microwave drying characteristics and kinetics of hematite pellets

Drying Kinetics and Color Change of Bamboo Shoots During Microwave Drying

Microwave Drying Optimization and Kinetic Modeling of Fly Ash from Municipal Solid Waste Incineration

Drying kinetics and upgrading characteristics analysis of Zhaotong lignite with microwave deep drying

Drying kinetics and energy efficiency of soot ash of smelting silicon manganese alloys under microwave heating

Heat Transfer Characteristics and Drying Kinetics of Hematite Thin Layer During Hot Air Convection

Microwave Vacuum Drying Properties and Kinetics Model of Radix Paeoniae Rubra Extract

Thin-layer drying characteristics and modeling of Ximeng lignite under microwave irradiation

Kinetic model research on drying characteristics of artificial magnetite green pellet

Experimental study on thin-layer microwave drying characteristics of Ximeng lignite

Research on the drying kinetics for the microwave drying of Y2O3–ZrO2 ceramic powder

Promoting Effect of Microwave Field on Gas Phase Diffusion Limited Magnetite Reduction in Carbon Monoxide

Reducing the Energy Consumption during Microwave Drying of Coal Slime Dough by Optimizing Parameters: Experiment and Modeling

EXPERIMENTAL STUDY ON THE REDUCTION OF IRON ORE AND COAL MIXED PELLETS OF HIGH PHOSPHORUS HEMATITE PRE-TREATED BY MICROWAVE IRRADIATION

Experimental Study on Microwave Drying Aluminum Hydroxide

Study on the drying characteristics of green pellets of ultrafine iron ore concentrate

Drying Kinetics of Microwave-Assisted Drying of Leaching Residues from Hydrometallurgy of Zinc

Kinetic Model Research on Drying Characteristics of Composite Green Pellet in Rotary Hearth Furnace

Investigation on drying characteristics of high titanium slag using microwave heating

Characteristic and kinetic study of the hot air-drying process of artificial limonite pellets

Mechanism study on the high-phosphorus hematite carbothermal reduction in microwave field