Abstract:Frequent mining stress disturbances in deep-earth resource extraction lead to different degrees of initial damage within cemented tailings backfill (CTB), which in turn changes the structural characteristics of the matrix and significantly affects the stability of CTB. To simulate the stress disturbance process of CTB during mining activities more realistically, cyclic loading and unloading disturbances were performed on the CTB. The stress disturbance levels (SDL) were 20, 40, 60, and 80% uniaxial compressive strength (UCS), and the stress disturbance counts (SDC) were 5, 10, 15, and 20 times, respectively. Subsequently, a series of experimental studies were conducted on CTB and disturbed damage CTB (DCTB) using UCS, nuclear magnetic resonance, ultrasonic pulse velocity (UPV) testing, and acoustic emission (AE) monitoring. The results show that the UCS of the backfill decreased with increasing SDL and SDC, except for 20% SDL and 5th SDC. The elastic modulus exhibited a rise at 20%–40% SDL and a fall at 60%–80% SDL. Compared with CTB, the stress–strain curve of DCTB showed a left shift - overlap - right shift - accelerated right shift change in the compacting stage with increasing SDL. Moreover, the porosity and UPV reflected by the mesoscopic structure correspond to the trend of UCS. The correlation mechanism between mesoscopic structure and macroscopic strength was determined, and the initial damage degree of DCTB was defined in terms of the average variation characteristics of macro-mesoscopic parameters. According to the AE monitoring results, it was observed that increasing SDL and SDC led to a significant increase in the AE energy active stage during loading. The damage curve established from the AE energy considering the initial damage degree rose exponentially. As the initial damage degree intensified, a noticeable and wide-range drop in the b -value before the peak was observed, indicating the occurrence of frequent large-scale fracture activities within the DCTB. Also, the damage degree of DCTB intensified, the collapse zone increased, and the failure mode of the backfill transformed from tensile to mixed tensile-shear damage. The research results can provide theoretical support and a reference basis for the stability analysis and strength design of the backfill under the action of mining stress.

Strengthening effect of cyclic load on siltstone and its macro–micro fracture mechanism

Strength dependence of siltstone under coupled cyclic-monotonic loading tests and the evolution of three-dimensional acoustic emission source

Study Of Microstructures Of Soft Clay Under Dynamic Loading Considering Effect Of Cyclic Stress Ratio And Frequency

Experimental Study on Degradation of Stiffness of Saturated Soft Clay under Undrained Cyclic Loading

STUDY ON STRAIN SOFTENING IN SATURATED SOFT CLAY UNDER CYCLIC LOADING

Effect of stress amplitude on mechanical and acoustic emission of sandstone under constant–cyclic loading

Experimental study on the mechanical characteristics of weakly cemented mudstone under different loading rates

Research and microscopic analysis of seepage characteristics of sandstone under low-frequency cyclic loading

Numerical simulation of micro crack evolution and failure modes of limestone under uniaxial multi-level cyclic loading

Experimental Study on Effects of Cyclic Loading Paths on Cracking Behavior and Fracture Characteristics of Granite

Experimental Investigation on Strength-Weakening Effect and Fracture Behavior of Red Sandstone under Coupled Static and Dynamic Cyclic Loadings

Fracturing and acoustic emission characteristics of saturated reservoir rocks under constant-amplitude-cyclic loading

Study on the fatigue properties and constitutive model of siltstone under the coupled action of dry‒wet cycles and cyclic loads

Evolution of Deformation Failure and Energy of Siltite and Significant Shear Fracture Structure Under Cyclic Loading

Experimental Study on Effect of Water on Progressive Failure Process of Siltstone

Acoustic emission characteristics and fracture mechanism of sandstone in open-pit mines under different types of cyclic loads

Macro-mesoscopic mechanical properties and damage progression of cemented tailings backfill under cyclic static load disturbance

Experimental investigation on shear strength deterioration at the interface between different rock types under cyclic loading

Mode-I failure and mechanical behavior of sandstone under cyclic loading: Laboratory testing and DEM simulation

Assessments of Tensile Characteristics and Degradation Mechanism of Sandstone Subjected to Wetting–Drying Cyclic Treatment

Mechanical properties of porous weakly cemented rocks under alternating creep-fatigue action