Abstract:Excessive exposure to noises, which corresponds to unwanted and/or unpleasant sounds, poses as a threat to people's health and can cause irritability, insomnia and even hearing loss. To attenuate noises, sound absorbers usually composed of porous materials are widely used. These, which appear as large networks of interconnected pores, are capable of absorbing medium and high sound frequencies, specially, transforming into heat the majority of the sound energy that reaches them. Such dissipations occur due to viscous, thermal and inertial losses resulted from interactions between the solid and fluid phases from which the porous materials are composed of. With the growing demand for acoustic comfort, one of the most important topics in noise control engineering is currently the search for sound absorption materials that provide attenuations in wide frequency ranges with minimum cost, weight and thickness. Fiberglass wool and melamine foam are widely used, and a variety of new porous materials are being developed, such as polymer micro- and nanofiber mats obtained by electrospinning. It is here investigated the acoustic potential of the electrospun polycaprolactone (PCL) fiber mat, normally used as a biomaterial. The sound absorption capacity of a material is given by its sound absorption coefficient ( α ), while its sound insulation capacity is denoted by its transmission loss (TL), and these are normally conflicting. In an impedance tube, through the transfer function and the transfer matrix methods, α and TL curves are here determined for samples of fiberglass wool and melamine foam with 25 mm width, and later these combined with a layer of approximately 0.3 mm of PCL fiber mat. With the addition of a fine layer of those polymeric fibers to both base materials, it was observed expressive gains in the sound absorption and transmission loss potentials in almost all the totality of the frequency range analyzed, which extends from 400 to 2500 Hz. It was also analyzed the morphology of the study materials through Scanning Electron Microscopy (SEM), and their porosities were determined through an optical approach with the aid of X-ray microtomography.

Freeze-cast porous Al2O3/MgO ceramics as potential acoustic sound absorption

High sound absorption characteristics of foamed alumina ceramics fabricated by gelcasting-foaming process

Preparation of Light Weight Porous Ceramics and Sound Absorption Performance Research

Freeze-cast porous silica ceramics with alumina nanofibers addition

Sound Absorption Characteristics of A High-Temperature Sintering Porous Ceramic Material

Optimizing Acoustic Performance: Electrospun Polycaprolactone Fiber Mat Associated with Melamine Foam and Fiber Glass Wool

Porous ceramics based on high-thermal-stability Al2O3–ZrO2 nanofibers for thermal insulation and sound absorption applications

Preparation and Properties of High Sound-Absorbing Porous Ceramics Reinforced by In Situ Mullite Whisker from Construction Waste

Air permeable alumina-based porous ceramics with high performance prepared by novel gel casting route

Fabrication of Porous Ceramics and Composites by a Novel Freeze Casting Process

Synthesis of macroporous ceramic with enhanced sound absorption capability in low and medium frequency

Enhanced Sound Absorption Performance of Porous Ceramics with Closed-Pore Structure

Sound absorption properties of porous aluminum

Role of solvent composition and sintering time on the porosity of α‐alumina monoliths produced by freeze casting

In situ growth magnesium borate whiskers and synthesis of porous ceramics for sound-absorbing

Nanoarchitectonics of RGO-Wrapped CNF/GO Aerogels with Controlled Pore Structures by PVA-Assisted Freeze-Casting Approach for Efficient Sound and Microwave Absorption

Sound Absorption Performance of a Lightweight Ceramic Foam

Porous Al2o3 Prepared Via Freeze Casting And Its Biocompatibility

Enhanced sound absorption properties of porous ceramics modified by graphene oxide films

Optimization for Sound Absorption Performance of Porous Ceramics Based on Orthogonal Experiments

The controllable microstructure of porous Al2O3 ceramics prepared via a novel freeze casting route