Abstract:Surprisingly few reports have been published, to date, on the structure-property-processing correlations observed in freeze-cast materials directionally solidified from polymer solutions, or ceramic or metal slurries. The studies that exist focus on properties of sintered ceramics, that is materials whose structure was altered by further processing. In this contribution, we report first results on correlations observed in alumina-chitosan-gelatin composites, which were chosen as a model system to test and compare the effect of particle size and processing parameters on their mechanical properties at a specific composition. Our study reveals that highly porous (>90%) hybrid materials can be manufactured by freeze casting, through the self-assembly of a polymer and a ceramic phase that occurs during directional solidification, without the need of additional processing steps such as sintering or infiltration. It further illustrates that the properties of freeze-cast hybrid materials can independently be tailored at two levels of their structural hierarchy, allowing for the simultaneous optimization of both mechanical and structural requirements. An increase in freezing rate resulted in decreases in lamellar spacing, cell wall thickness, pore aspect ratio and cross-sectional area, as well as increases in both Young's modulus and compressive yield strength. The mechanical properties of the composite scaffolds increased with an increasing particle size. The results show that both structure and mechanical properties of the freeze-cast composites can be custom-designed and that they are thus ideally suited for a large variety of applications that require high porosity at low or medium load-bearing capacity.

Freeze-Casted Porous Lamellar-Structured Alumina Ceramics and Polymer-Infiltrated Composites: Synergistic Enhancement of Structural Properties

Cost-effective Fabrication of Bio-Inspired Nacre-Like Composite Materials with High Strength and Toughness

Preparation of Fly Ash-Based Porous Ceramic with Alumina as the Pore-Forming Agent

Novel MMC Microstructures Prepared by Melt Infiltration of Reticulated Ceramic Preforms

Improvement of Microstructural Controllability of Cellular Ceramic for Multifunctional Composites

Fabrication and Characterisation of Alumina/aluminium Composite Materials with a Nacre-Like Micro-Layered Architecture

Fabrication of Porous Alumina Ceramics with Directional Pore Channels Structure by Freeze-Gel Casting Processing

Alumina Porous Ceramics Obtained by Freeze Casting: Structure and Mechanical Behaviour under Compression

Ceramics with Special Porous Structures Fabricated by Freeze-Gelcasting: Using tert-Butyl Alcohol as a Template

Multi-directional freeze-casting of interpenetrating phase composites with multi-aligned structure, nearly isotropy, high performance

Strong hybrid cellular/lamellar ceramic/polymer composites via emulsification freeze casting

Structure-property-processing correlations in freeze-cast composite scaffolds

Preparation of porous alumina ceramic with ultra-high porosity and long straight pores by freeze casting

Effect of Alumina Fiber Content on Pore Structure and Properties of Porous Ceramics

Preparation of Porous Ceramic Materials by Alumina Fiber Framework

Freeze casting of arbitrary‐shaped porous ceramics

Freeze-Casting of Alumina and Permeability Analysis Based on a 3D Microstructure Reconstructed Using Generative Adversarial Networks

Fabrication, microstructure and physico-mechanical properties of highly porous acicular mullite ceramic foams by freeze casting method

Air permeable alumina-based porous ceramics with high performance prepared by novel gel casting route

Multi-directional freeze casting of porous ceramics with bone-inspired microstructure

Poly(vinyl alcohol) freeze casts with nano-additives as potential thermal insulators