Abstract:View Video Presentation: https://doi.org/10.2514/6.2022-1114.vid The Rotating Detonation Engine (RDE) has gained increasing attention in recent years for its potential advantages over typical deflagration combustion. A Micro-RDE design with an outer diameter of 28mm operating on Nitrous Oxide and Ethylene was recently developed, which stretched the limits of small-scale detonation engines. The testing on this rig has shown a stable one wave mode detonation with frequencies reaching 16.8 kHz. Key parameters that influence the detonation wave mode are cell size, fill height, and wave speed, which are heavily influenced by injection schemes. Previous testing utilized a partially-premixed jets in crossflow (JIC) injection scheme, while tests before that used a traditional JIC scheme. A simplex and counter-jet injection scheme were added to the configuration to explore other options of injecting the fuel and oxidizer. The goal of this research was to characterize the operating limits of the injection schemes and understand their effects on the detonation wave stability in a small-scale RDE. The traditional JIC scheme produced the largest operating map detonating at oxidizer mass flow rates from 55 g/s to as low as 12 g/s. However, its average wave speed, 1106 m/s, was lower compared to the Chapman-Jouget detonation speeds than some other results, Testing with the simplex injection scheme resulted in wave speeds averaging 1167 m/s and produced the most limited operating map as detonations in this configuration only detonated at fuel rich equivalence ratios. The partially-premixed JIC produced higher wave speeds reaching an average 1490 m/s while achieving a lower limit of 45 g/s. The highest wave speeds of 1518 m/s were achieved for a specific configuration of the offset counter-jet injection configuration over a limited set of conditions.

Effect of channel expansion angle near injector outlet on a rotating detonation engine performance

Visualization and thrust measurement of rotating detonation engine with various channel expansion angles

The Influence of Plug Nozzle and Laval Nozzle on the Flow Field and Performance of Non-Premixed Rotating Detonation Combustor

Rotating Detonation Rocket Engine Operability Under Varied Pressure Drop Injection

Numerical Study of the Effects of Injection Conditions on Rotating Detonation Engine Propulsive Performance

Combustion Structure of a Cylindrical Rotating Detonation Engine with Liquid Ethanol and Nitrous Oxide

Analysis on Propulsive Performance of Hollow Rotating Detonation Engine with Laval Nozzle

Experimental investigation on the performance of the variable cross section rotating detonation engine

Injection Studies on a Small-Scale Rotating Detonation Engine

Characterization of wave modes in a kerosene-fueled rotating detonation combustor with varied injection area ratios

Theoretical and Numerical Investigation on Total Pressure Gain in Rotating Detonation Engine

Shock Propagation Through a Square Injector: Investigation into Rotating-Detonation Engine Injector Dynamics

Nitrous Oxide/Ethanol Cylindrical Rotating Detonation Engine for Sounding Rocket Space Flight

Rotating Detonation Engine Injection Velocity Limit And Nozzle Effects On Its Propulsion Performance

Experimental Study on Upstream Pressure Characteristics of Rotating Detonation Engine with Methane and Oxygen-Enriched Air

Computational Assessment of Inlet Backflow Effects on Rotating Detonation Engine Performance and Operability

Nonidealities in Rotating Detonation Engines

Investigation of pressure gain characteristics of RDE with Tesla valve inlet scheme

Analytical and Numerical Study of the Expansion Effect on the Velocity Deficit of Rotating Detonation Waves

Numerical Investigation of Rotating Detonation Engine Propulsive Performance

Investigation of flow field characteristics and performance of carbon-hydrogen/oxygen-rich air rotating detonation engine