Abstract:Abstract The electrodeposition of aluminum on mild steel in a molten salt electrolyte consisting of a mixture of AlCl 3 /NaCl/KCl (weight percent ratio of 80:10:10) was studied. Parametric studies were carried out to evaluate the effect of different parameters such as current density, electrolysis time, and intermediate coating layer on the coating morphology and coating-to-substrate adhesion. The quality and morphology of the coating were investigated using scanning electron microscope (SEM) and x-ray map analyses. The effect of heat treatment of the coated samples on the interface stability and formation of intermetallic compounds at the Al-Fe interface was also investigated. Cross-sectional examination by SEM as well as energy dispersive spectroscopy (EDS) line scan showed that upon annealing at temperatures in the range of 350 °C–550 °C, brittle Fe-Al intermetallic layers were formed at the interface. This shows that high-temperature service conditions can adversely affect the coating properties. The apparent activation energy of the formation of such intermetallic layers was calculated based on thickness measurements on these layers. The optimum conditions for electroplating were determined as current density of 0.022 A.cm −2 and electroplating time of 60 min. Potentiodynamic polarization tests were used to evaluate the corrosion resistance of the samples in 3.5 wt% NaCl solution. Considering the corrosion rate of coated samples which is much lower than the bare substrate, it was concluded that the electrodeposited coatings could efficiently protect the steel substrate against corrosion in corrosive media.

Study on the mechanism of preparing metallic iron from soluble anode

Direct Electrodeposition of High-Purity Iron from Fe2O3 in Molten Calcium Chloride

The Recycling of Ferric Salt in Steel Pickling Liquors: Preparation of Nano-sized Iron Oxide

Electrochemical Mechanism and Preparation of Cr–Low-Carbon Steel Composite in a NaCl–KCl–NaF–Cr2O3 Molten Salt

The Preparation of High-Purity Iron (99.987%) Employing a Process of Direct Reduction–Melting Separation–Slag Refining

Study on Diffusion Kinetics of Chromium and Nickel Electrochemical Co-Deposition in a NaCl–KCl–NaF–Cr2O3–NiO Molten Salt

Molten Oxide Electrolysis Using Copper-Containing Carbon-Saturated Molten Iron Anode

Experimental investigation on the formation mechanism of the TiFe alloy by the molten-salt electrolytic titanium concentrate

Impurity Behavior in Aluminum Extraction by Low-Temperature Molten Salt Electrolysis

On the formation of dendritic iron from alkaline electrochemical reduction of iron oxide prepared for metal fuel applications

Molten salt electrodeposition of aluminum on mild steel: effect of process parameters on surface morphology and corrosion properties

Enhanced electro-generated ferrate using Fe(0)-plated carbon sheet as an anode and its online utilization for removal of cyanide

Effect of Electrolysis Temperature on the Preparation of FeO by Molten Salt Electrolysis

A Novel Method to Remove Iron Impurity from Aluminum

Flame synthesis of Fe3O4/Fe2O3 on stainless steel grid surfaces to improve anodic electrochemical properties

A novel method for effective solidifying chromium and preparing crude stainless steel from multi-metallic electroplating sludge

Ductile Iron: A Low-Cost Optimal Anode Material for Electrochemical Generation of Ferrate (VI)

Direct electrochemical preparation of sodium ferrate

Extraction of Cu and Ni from Low-Ni Matte by a Combined Chemical Precipitation and Molten Salt Electrolysis Approach

Effect of metallic content on sintering behavior of NiFe2O4-based cermet inert anode for aluminum electrolysis

Modulating Electrolyte Solvation Structure with Fe-Embedded Carbon Matrix Substrates for Robust Lithium-Metal Plating