Abstract:The microfluid jet polishing (MFJP) process is a manufacturing technology in which small abrasive particles (such as diamond, alumina, and ceria) are premixed with a carrier fluid (typically water) to form a liquid suspension that is pressurized and expelled through a nozzle for material removal. The resulting microjet beam—with a typical nozzle exit diameter in the range from 0.1 to 1.0 mm—impinges the workpiece surface for material removal by erosion and/or abrasion and produces an ultraprecision surface. This work applies a computational fluid dynamics (CFD) model to analyze the key phenomena in the interaction of the liquid suspension and the workpiece surface. The liquid film characteristics (film height, minimum film height, positions of the minimum film height, and hydraulic jump) obtained from the CFD simulations are compared with the results derived from empirical formulations found in the literature. Subsequently, the numerical results are utilized to investigate the impact velocity, pressure distribution, and shear stress caused by the suspension on the workpiece surface. It is observed that the shear stress strongly depends on the injection pressure of the liquid suspension and is weakly dependent on the abrasive suspension concentration (the liquid suspension with different densities, viscosities, and surface tensions). Additionally, the particle behavior is investigated in order to estimate the impact velocity and to identify the impact and erosion zones of the liquid suspension on the workpiece surface. Numerical results indicate that ~50% of total particles are impinging the workpiece surface almost perpendicularly (with a mean impact angle of ~86 degrees) for the first time in the stagnation region, where they are strongly decelerated by the carrier fluid before they reach the workpiece surface. These particles, however, rebound on the surface and are reaccelerated by the carrier fluid, impinging the workpiece surface further in the radial direction.

Jetting Phenomenon in Cold Spray: A Critical Review on Finite Element Simulations

Numerical Study on Particle Behavior and Deposition Accuracy in Cold Spray Additive Manufacturing

Research Progress on Numerical Simulation of the Deposition and Deformation Behavior of Cold Spray Particles

Dynamic Modeling of Micro- and Nano-Sized Particles Impinging on the Substrate During Suspension Plasma Spraying

Numerical Models For Viscoelastic Liquid Atomization Spray

A meshless computational framework for studying cold spray additive manufacturing including large numbers of powder particles with diverse characteristics

Modeling of Micro- and Nanoparticle Characteristics in DC Suspension Plasma Spray

Investigation of Unsteady Flow Behavior of Cryogen-Spray Coupled with Cold Air Jet

Visualizing and Quantifying Deformation Microstructures in Cold Sprayed Materials

Modeling Aspects of High Velocity Impact of Particles in Cold Spraying by Explicit Finite Element Analysis

SPH modeling and investigation of cold spray additive manufacturing with multi-layer multi-track powders

Examination of the Estimating Approaches for the Critical Velocity in Cold Spraying

Application of Multiphase Particle Methods in Atomization and Breakup Regimes of Liquid Jets

Numerical study on the atomization mechanism and energy characteristics of synthetic jet/dual synthetic jets

Integral Numerical Modeling of the Deposition Profile of a Cold Spraying Process As an Additive Manufacturing Technology

Numerical Simulation of Jet Mode in Electrospraying of Newtonian and Viscoelastic Fluids

Beating the jetting regime

Towards an Understanding of Multiphase Fluid Dynamics of a Microfluid Jet Polishing Process: A Numerical Analysis

Particle-based Simulation of Cold Spray: Influence of Oxide Layer on Impact Process

Experimental and Numerical Study of Al2219 Powders Deposition on Al2219-T6 Substrate by Cold Spray: Effects of Spray Angle, Traverse Speed, and Standoff Distance

Cold Spray: Over 30 Years of Development Toward a Hot Future