Abstract:The cooling technology of hot turbine components has been a subject of continuous improvement for decades. In high-pressure turbine blades, the regions most affected by the excessive corrosion are the leading and trailing edges. In addition, high Kt regions at the hot gas path are exposed to cracking due to the low and high cycle fatigue failure modes. Especially in the case of a nozzle guide vane, the ability to predict thermally driven loads is crucial to assess its life and robustness. The difficulties in measuring thermal properties in hot conditions considerably limit the number of experimental results available in the literature. One of the most popular test cases is a NASA C3X vane, but coolant temperature is not explicitly revealed in the test report. As a result of that, numerous scientific works validated against that vane are potentially inconsistent. To address that ambiguity, the presented work was performed on a fully structural and a very fine mesh assuming room inlet temperature on every cooling channel. Special attention was paid to the options of the k-ω SST (shear-stress transport) viscosity model, such as Viscous heating (VH), Curvature correction (CC), Production Kato-Launder (KT), and Production limiter (PL). The strongest impact was from the Viscous heating, as it increases local vane temperature by as much as 40 deg. The significance of turbulent Prandtl number impact was also investigated. The default option used in the commercial CFD code is set to 0.85. Presented study modifies that value using equations proposed by Wassel/Catton and Kays/Crawford. Additionally, the comparison between four, two, and one-equation viscosity models was performed.

Numerical Estimation of Convective Heat Transfer Coefficient and Heat Flux for a Supersonic Rocket Nozzle

Numerical Study of Heat Flux Reduction Mechanism of the Counterflowing Jet in Rarefied Flows

Numerical Simulation of Hypersonic Thermochemical Nonequilibrium Flows Using Nonlinear Coupled Constitutive Relations

Computational modeling of heat transfer and flow separation in supersonic cooled nozzles: Parametric study

Numerical Simulation Coupling on Fluid Flow and Heat Transfer in Nozzle and Equipment Cabin of Solid Rocket Motor during Operation Process

A Numerical Study of Supercritical Forced Convective Heat Transfer of N-Heptane Inside A Horizontal Miniature Tube

Modeling and Analysis of Fluid-Solid Coupling Heat Transfer and Fluid Flow in Transonic Nozzle

Coupled Flow-Thermal Analysis of a Rocket Nozzle with Charring Ablative Thermal Protection System

Numerical Study of Supersonic Film Cooling in Diverging Section of Nuclear Rocket Laval Nozzle

A Coupled Heat Transfer Calculation Strategy for Composite Cooling Liquid Rocket Engine

Based on Fluent Numerical Calculation of Refractive Index on Rocket Engine Nozzle Plume

Enhancement of Film Cooling Effectiveness in a Supersonic Nozzle

Numerical Modeling of Turbulent Heat Transfer of a Nanofluid at Supercritical Pressure

Numerical Simulation of Inner Flow Field of a Pintle Injector Variable Thrust Rocket Engine

Efforts to Identify the Most Suitable RANS Turbulence Model for Accurate Conjugate Heat Transfer Prediction in Regenerative Cooled Nozzles

Investigation on the Transpiration Cooling of a Liquid Rocket Nozzle

Numerical Simulation of High Temperature Transpiration Cooling in Cylindrical Porous Channels

Friction factor and heat transfer prediction of rocket engine cooling channels in numerical simulations with high roughness Reynolds number

Numerical modeling of heat transfer behavior for two-phase flow in a nozzle considering phase change

Thermal-Fluid-Solid Coupling-Parametrical Numerical Analysis of Hot Turbine Nozzle Guide Vane

Numerical study of the separation of a turbulent boundary in rocket engine nozzles with an optimized supersonic part