Abstract:Gradient nanostructured (GNS) metallic materials have shown significant potential in achieving excellent mechanical properties. However, the underlying strengthening mechanisms resulting from plastically inhomogeneous deformation in GNS materials, particularly those involving nanotwinned structures, remain inadequately understood. In this study, a gradient nanograined-nanotwinned (GNNT) surface layer was generated on a Cu-Al alloy using the severe plastic deformation technique known as single-point diamond turning. Uniaxial tensile and localized micropillar compression tests were conducted to compare the mechanical properties of GNNT samples with conventional gradient nanograined (GNG) and uniform coarse-grained (CG) Cu/Cu-Al counterparts. The results revealed that the GNNT samples exhibit excellent strength-ductility synergy, with a yield strength of approximately 329 MPa, tensile strength of around 477 MPa, and uniform ductility of about 48%, thereby demonstrating remarkable strain hardening capacity and mechanical stability. These characteristics are further supported by the observed strong back stress effect, well-preserved mobile dislocation density, and effective suppression of grain coarsening in the GNNT surface layer. In contrast to the evident mechanically induced grain coarsening through grain boundary (GB) migration in the GNG surface layer, grain coarsening through twin boundary (TB) migration in GNNT surface layers is effectively inhibited by Lomer-Cottrell (L-C) locks formed by TB-stacking fault and TB-TB intersections, resulting in significantly enhanced structural stability. Furthermore, the L-C locks also extensively contribute to the high density of mobile dislocations observed in the GNNT samples. These findings provide valuable insights into the optimization of GNS structures for achieving excellent strength-ductility synergy in metallic materials.

A low-to-high friction transition in gradient nano-grained Cu and Cu-Ag alloys

Stress-dependent subsurface structural transformations of gradient nanograin Ti-6Al-4V alloy and its impact on wear behavior

Sliding wear-induced chemical nanolayering in Cu–Ag, and its implications for high wear resistance

Enhanced frictional performance in gradient nanostructures by strain delocalization

Effects of normal load and velocity on the dry sliding tribological behaviour of CoCrFeNiMo0.2 high entropy alloy

Mechanisms of near-surface structural evolution in nanocrystalline materials during sliding contact

Computational Modelling of Frictional Deformation of Bimodal Nanograined Metals

Grain Coarsening Behavior in a Nanocrystalline Copper Subjected to Sliding Friction

Excellent Strength-Ductility Synergy of Cu-Al Alloy with a Gradient Nanograined-Nanotwinned Surface Layer

Self-lubricating behavior of a PdCuNiP glassy alloy by in-situ nanocrystallization during dry friction

The Role of the Transfer Layer on the Sliding Wear Behaviour of a Cu-15Ni-8Sn Alloy under Different Loads

Effect of Counterface Materials on Dynamic Recrystallized Structure and Wear Resistance of Nanostructured Cu

Remarkable Wear Resistance in a Complex Concentrated Alloy with Nanohierarchical Architecture and Composition Undulation

Dry sliding tribological properties and subsurface structure of nanostructured copper at liquid nitrogen temperature

Mechanisms of remarkable wear reduction and evolutions of subsurface microstructure and nano-mechanical properties during dry sliding of nano-grained Ti6Al4V alloy: A comparative study

A Gradient Nanostructure Generated in Pure Copper by Platen Friction Sliding Deformation

Nanoscale self-organization reaction in Cu-Ag alloys subjected to dry sliding and its impact on wear resistance

The Gradient Structure in the Surface Layer of an Al-Zn-Mg-Cu Alloy Subjected to Sliding Friction Treatment

Study on the mechanical properties of gradient grains based on molecular dynamics

Linking microstructural evolution and macro-scale friction behavior in metals

Friction Control by Tailoring Deformation Mechanism of Interfacial Grains in Metals