Abstract:As we know, 3DPC is printed layer by layer compared with mold-casting conventional concrete. Pore structure and layer-to-layer interface are two main aspects of the internal structure for 3DPC, which decide 3DPC's mechanical performance. The layer-to-layer interface caused by printing is specific to 3DPC. The emphasis of this study lies in the layer-to-layer interfaces of 3DPC. The first aim of this study is to quantify the characteristics of the layer-to-layer interface and therefore characterize different aspects of the interfaces. The second aim of this study is to explore how the internal structure of printed concrete influences the mechanical performance of 3DPC. This research set out to design a series of experimental comparisons between 3DPC and casted concrete with the same compositions. Mechanical tests, i.e., compressive stress, ultrasonic Pulse Velocity test, flexural tension, and tension splitting, as well as the Ultrasonic Pulse Velocity test, were performed to check the mechanical performance of 3DPC. Contrary to what has often been expected, the mechanical test results showed the printed concrete has a quality not worse than casted concrete with the same recipe. Meanwhile, the X-ray computed tomography (X-CT) is used to characterize the internal structure, pore shapes, and interfaces of 3DPC. First, the investigation revealed that the lower total porosity and fewer big voids could be the fundamental causes meaning 3DPC has a better mechanical performance than casted concrete. Second, the statistics based on aspect ratio show that the distribution curves follow similar trends, regardless of the printed or casted concrete. Third, this study quantified the depth of the different interfaces for 3DPC. The results suggest that the porosity in an interface varies in a range. The author's pioneer work has contributed to our present understanding of the interfaces of 3DPC.

Influence of steel fiber on the water absorption of 3D printed concrete

Investigation of the Internal Structure of Hardened 3D-Printed Concrete by X-CT Scanning and Its Influence on the Mechanical Performance.

Properties and Microstructures of 3D Printable Sulphoaluminate Cement Concrete Containing Industrial By-Products and Nano Clay

Mechanical and macrostructural properties of 3D printed concrete dosed with steel fibers under different loading direction

Investigation of the rheological and mechanical properties of 3D printed eco-friendly concrete with steel slag

Investigation of steel wire mesh reinforcement method for 3D concrete printing

Modification effect of nanosilica and polypropylene fiber for extrusion-based 3D printing concrete: Printability and mechanical anisotropy

Influence of print speed and nozzle diameter on the fiber alignment in 3D printed ultra-high-performance concrete

Enhancing Mechanical Properties of Concrete with 3D Printed Vascular Networks via Carbonation strengthening

Investigation on Mechanical and Microstructure Properties of Steel Fiber Reinforced Concrete

3D Printing of Fiber-Reinforced Calcined Clay-Limestone-Based Cementitious Materials: From Mixture Design to Printability Evaluation

A study of the effects of MWCNTs on the fresh and hardened state properties of 3D printable concrete

Eco-Friendly 3D-Printed Concrete Using Steel Slag Aggregate: Buildability, Printability and Mechanical Properties

Study of 3D printed concrete with low-carbon cementitious materials based on its rheological properties and mechanical performances

Effect of Nanostructured Silica Additives on the Extrusion-Based 3D Concrete Printing Application

Influence of Printing Interval on the Imbibition Behavior of 3D-Printed Foam Concrete for Sustainable and Green Building Applications

Utilization of antimony tailings in fiber-reinforced 3D printed concrete: A sustainable approach for construction materials

Performance of 3D-Printed Beams and Slabs Using Self-Sensing Cementitious Composites and DIC Method

3D printing concrete with recycled coarse aggregates: The influence of pore structure on interlayer adhesion

Mechanical behaviors of 3D printed lightweight concrete structure with hollow section

Shrinkage and Cracking Properties of Cellulose Fiber–Concrete Composites for 3D Printing by Leveraging Internal Curing