Abstract:With the development of the ultra-large scale integrated circuit (ULSI) technology, CoSi2 has become a leading candidate for contact materials in electronic devices due to its linewidth-independent low resistivity and small lattice mismatch with Si substrate [1]. Among many methods to fabricate epitaxial CoSi2 films, solid phase epitaxy (SPE) is a very important one [2]. Ti-interlayer mediated epitaxy (TIME) [3] and oxide mediated epitaxy (OME) [4] can be regarded as improvements of SPE. In SPE, the Co film is usually deposited at room temperature and the as-deposited Co films are usually amorphous [2, 5]. During low temperature annealing, the crystallization of Co film can be observed; yet during high temperature annealing, especially rapid thermal annealing (RTA), this process cannot be observed [5]. So in high temperature RTA, we cannot tell whether the Co film has undergone crystallization before the formation of silicides. This fact suggests that the formation of silicides during high temperature RTA may be the result of the reaction between amorphous Co film and Si substrate, not the reaction between crystalline Co film and Si substrate. Based on this consideration, we expect the reaction between real crystalline Co film and Si substrate to produce some results different from previous reports. Si(111) substrate was chosen because the epitaxial growth of CoSi2 film on Si(111) is not so complicated as that on Si(100). The purpose of this letter is to study the reaction between crystalline Co film and Si(111) substrate. n-Typed Si(111) with a resistivity of 4‐4.8� · cm were ultrasonically cleaned in acetone, rinsed in deionized water, etched in HF : H2O2(1 : 1), rinsed in deionized water again, and then loaded into the e-gun evaporation system. The base pressure of the system was 1.2 × 10 −8 Torr. During the deposition process, the vacuum level was 2.3 × 10 −7 Torr. Crystalline Co films of 150 nm thickness were obtained by heating the substrate to 150 ◦ C during the e-gun evaporation. Subsequent ex situ RTA was carried out in a high vacuum of 3.0 × 10 −6 Torr at temperatures between 470 and 850 ◦ C for 3 min. X-ray diffraction (XRD) was used to investigate the phases and their preferential orientations formed during the Co-Si reaction. The composition of the film was analyzed by auger electron spectroscopy(AES) and the crystalline properties of CoSi2 films were evaluated by reflection high-energy electron diffraction (RHEED).

The solid-phase ion-plasma method and thermoelectric properties of thin CrSi2 films

Formation of thin Crsi2 films by the solid-phase ion-plasma method and their thermoelectric properties

Thickness Dependence of Properties of Plasma-Deposited Amorphous SiO2 Films

Properties of plasma-deposited amorphous SiO2 films

Deposition of Dense SiO2 Thin Films for Electrical Insulation Applications by Microwave ECR Plasma Source Enhanced RF Reactive Magnetron Sputtering

Properties of CrSi2 Layers Obtained by Rapid Heat Treatment of Cr Film on Silicon

Ion implantation effects on the microstructure, electrical resistivity and thermal conductivity of amorphous CrSi2 thin films

CrSi2 films synthesized by high current Cr ion implantation and their physical properties

Impact of Cr content on the thermoelectric properties of the Cr/Sb co-doped Mg2.2−xCrx(Si0.3Sn0.7)0.98Sb0.02 compound

Fabrication and Characterization of Thermoelectric CrSi2 Compound by Mechanical Alloying and Spark Plasma Sintering

Enhancement Of Thermoelectric Power Factor In Crsi2 Film Via Si:B Addition

Solid phase reaction between crystalline, (002) oriented Co film and Si(111) substrate: Preferential orientations of silicides

Silicide formation by solid-state diffusion in MO/Si multilayer thin films

Thermoelectric effect of silicon films prepared by aluminum-induced crystallization

Cr Silicate as a Prototype for Engineering Magnetic Phases in Air-Stable Two-Dimensional Transition-Metal Silicates

Energy filtering enhancement of thermoelectric performance of nanocrystalline Cr-Si composites

Structural and Mechanical Properties of CrN Thin Films Deposited on Si Substrate by Using Magnetron Techniques

Thermoelectric Effect of Silicon Films with Shallow- and Deep-Level Acceptors

Study on Solid Phase Crystallization of Silicon Films Deposited on Different Substrates

Formation of Mn4Si7/Si(111), CrSi2/Si(111), and CoSi2/Si(111) Thin Film and Evaluation of Their Optically Direct and Indirect Band Gap

Growth and characterization of crystalline Bi2Se3 thin films on flexible metal foils by magnetron sputtering system