Abstract:As a result of negligible connected porosity—and thus, minimal matrix permeability—the fluid-transport characteristics of crystalline rocks are strongly influenced by the fractures at all scales. Understanding the flow behaviour of fractured rock under extreme stress and temperature conditions is essential for safe and effective deep geo-engineering applications, such as deep geothermal recovery, geological nuclear waste disposal, oil and gas extraction, geological storage and deep mining operations. Therefore, this study aims to investigate the flow characteristics of mechanically fractured Australian Strathbogie granite under a wide range of stress (confining pressures 1–80 MPa) and temperature conditions (20 °C to 350 °C). The study utilised a sophisticated high-temperature, high-pressure tri-axial setup capable of simulating extreme geological conditions, followed by a numerical simulation. According to the experimental results, a linear increment in the steady-state flow rate was observed, with increased injection pressure for the experimental conditions considered. Therefore, linear laminar Darcy flow was considered, and the fracture permeability was calculated using the cubic law. It was found that stress and temperature strongly depend on the flow of fluid through fractures. The steady-state flow rate decreased exponentially with the increase in normal stress, showcasing fracture shrinkage with an increment in effective stress. With regard to permeability through the fractures, increasing temperature was found to cause an initial reduction in fracture permeability due to an increased interlock effect (induced by thermal overclosure), followed by increments because of the thermally induced damage. Furthermore, the increasing temperature caused significant non-linear increments in the fluid flow rates due to the associated viscosity and density reduction in water. Considering the laboratory-scale flow-through exercises, a fully coupled numerical model that can predict hydro–thermo–mechanical variations in the reservoir rocks was developed using the COMSOL Multiphysics simulator. The developed model was calibrated, utilising the temperature- and pressure-dependent properties of granite rocks and fluid (water); was validated against the experimental results; and was used to predict the permeability, pressure development and strain of rock samples under extreme conditions, which were difficult to achieve in the laboratory.

Permeability Evolution of Rough Fractures in Gonghe Granite Subjected to Cyclic Normal Stress at Elevated Temperatures: Experimental Measurements and Analytical Modeling

Thermal Effect on Permeability in a Single Granite Fracture: Experiment and Theoretical Model

Thermal Stimulation Mechanical Response and Shear Dilatation Predictive Model Improvement of Granite Fractures in an Enhanced Geothermal System

Study on permeability evolution and damage mechanism along the EGS fracture in heat mining stage under thermal stress/cracking

Coupled Effects of Elastic and Plastic Deformation on Hydraulic Properties of the Geothermal Fracture Induced by Cyclic Loading-Unloading Processes

Inversion in the permeability evolution of deforming Westerly granite near the brittle-ductile transition

Hydraulic properties of stressed granite fractures with heat-induced void alteration

Effect of water-cooling shock on fracture initiation and morphology of high-temperature granite: Application of hydraulic fracturing to enhanced geothermal systems

Impact of fracture shear dilation on long-term heat extraction in Enhanced Geothermal Systems: Insights from a fully-coupled thermo-hydro-mechanical simulation

Unloading-induced Permeability Recovery in Rock Fractures

A model for characterization of crack closure stage in stress–strain curves of Suizhou granite after exposure to various thermal shocks

Temperature-Dependent Permeability Model of Granite After Thermal Treatment Based on Energy Dissipation Theory and Fractal Theory

Shear Induced Seepage and Heat Transfer Evolution in a Single-Fractured Hot-Dry-Rock

Effects of cyclic fatigue loads on surface topography evolution and hydro-mechanical properties in natural and artificial fracture

Radial Flow Behaviors of a Rough Beishan Granite Fracture under Normal and Thermal Loadings

Thermo-mechanical Coupling Characteristics of Granite under Triaxial Pressures and Ultrahigh Heating Rates

Experimental investigation of thermal cycling effect on fracture characteristics of granite in a geothermal-energy reservoir

Experimental and Numerical Investigation of the Flow Behaviour of Fractured Granite under Extreme Temperature and Pressure Conditions

Permeability Evolution of Thermally Cracked Granite with Different Grain Sizes

Study on the Accuracy of Fracture Criteria in Predicting Fracture Characteristics of Granite with Different Occurrence Depths

Effect of Cyclic Thermal Shock on Granite Pore Permeability