Abstract:The MAX phase has attracted much attention due to its unique properties combined with the merits of both metal and ceramic, including the low density, high electrical conductivity and good oxidation resistance, which makes it significant for possible applications in various high temperature or other environments. There is a lot of research work on Ti2AlX (X=C, N). However little research about thermodynamic properties at high pressure is carried out. So we study the structural, mechanical and thermodynamic properties of Ti2AlC and Ti2AlN at various pressures and temperatures. The first-principles calculations based on electronic density-functional theory framework are used to investigate the properties at various pressures. The cut-off energy is 350 eV. Converged results are achieved with 10102 special K-point meshes. The self-consistent convergence of total energy is set to be 5.010-6 eV/atom. According to the calculated structural parameters at various pressures, we can find that the ratios V/V0 (V0 denotes the system volume at 0 GPa) of Ti2AlX are reduced by 20.59% and 18.93%, respectively, so the compressibility of the system is strong. As the internal pressure increases, the curves of V/V0 become gentle. Then we calculate elastic constants at pressures ranging from 0 to 50 GPa in steps of 10 GPa. It is obvious that the Ti2AlX is mechanically stable because all of the elastic constants satisfy the Born stability criteria. The bulk modulus, shear modulus and Young's modulus linearly increase with internal pressure increasing, implying that the pressure can improve the resistance to volume deformation. The ductility and brittleness can be judged according to Pugh's criterion (ratio of bulk modulus to shear modulus B/G), and the brittle nature turns into ductile nature in a pressure range of 40-50 GPa for the Ti2AlX since the value of B/G exceeds 1.75. Finally, we study the thermodynamic properties at various pressures and temperatures based on the quasi-harmonic Debye approximation theory, including the bulk modulus, heat capacity and thermal expansion coefficient. The bulk modulus decreases with temperature increasing but increases with pressure increasing. The heat capacity at constant volume Cv and the heat capacity at constant pressure Cp have the same variation tendency, while Cv obeys the Dulong-Petit limit. It is easy to see that temperature and pressure have opposite influences on heat capacity and the effect of temperature is more significant than that of pressure. The effects of temperature and pressure on linear expansion coefficient mainly occur at low temperature and the effect of pressure is not so considerable when the pressure exceeds 30 GPa. Above all, the effects of temperature and pressure on thermodynamic properties are inverse.

Thermodynamic properties of sodium pentatitanate (Na8Ti5O14)

Thermodynamic properties of sodium trititanate (Na 2 Ti 3 O 7 ) at high temperature (298.15‐1403 K)

Low-temperature heat capacities and thermodynamic properties of Mn<sub>3</sub>(HEDTA)<sub>2</sub>·10H<sub>2</sub>O

Low-temperature Heat Capacities and Thermodynamic Properties of Mn-3(HEDTA)(2)center Dot 10H(2)O

ChemInform Abstract: High Pressure in Situ Differential Thermal Analysis of Na0.5Bi0.5TiO3 Phase Transitions Up to 5 GPa.

Theoretical Investigation of the High Pressure Structure, Lattice Dynamics, Phase Transition, and Thermal Equation of State of Titanium Metal

Excellent Catalysis of Various TiO 2 Dopants with Na 0.46 TiO 2 in Situ Formedon the Enhanced Dehydrogenation Properties of NaMgH 3

Sodium Alanate In-Situ Doped with Ti2C MXene with Enhanced Hydrogen Storage Properties

Thermodynamic properties study of polyoxometalate Na7

Pressure and Temperature-Dependent Optical Properties of TiTa2O7

Structural, Mechanical, and Thermodynamic Properties of Ti2AlX (X = C, N) at High Pressure

Excellent Catalysis of Various TiO<sub>2</sub> Dopants with Na<sub>0.46</sub>TiO<sub>2</sub> in Situ Formed on the Enhanced Dehydrogenation Properties of NaMgH<sub>3</sub>

First Principles Studies on the Elastic, Thermodynamic Properties and Electronic Structure of Ti15−xMoxSn Compounds

Thermal and Lattice Dynamical Properties Ofna8si46clathrate

Thermodynamic data and properties of polyoxometalate Na6V10O28

Phase equilibria in the TiO2–Nb2O5 system: New experiments and thermodynamic modeling

Equations of State of Co 2 TiO 4 -Sp, Co 2 TiO 4 -CM, and Co 2 TiO 4 -CT, and Their Phase Transitions: an Experimental and Theoretical Study

Structural, dielectric and ferroelectric studies of thermally stable and efficient energy storage ceramic material: (Na0.5-xKxBi0.5-xLax)TiO3

Low-temperature Combustion Synthesis and Characterization of Nanosized Tetragonal Barium Titanate Powders

Thermophysical Properties of Lithium Nitrate Trihydrate from (253 to 353) K

Molten-salt Synthesis of BaTiO3 Powders and Their Atomic-Scale Structural Characterization