Abstract:Objective: The goal of this work was to set up a high throughput procedure for the determination of fatty acid methyl esters (FAMEs) in cosmetic castor oils using flow injection - electrospray ionization - high resolution mass spectrometry, and to demonstrate the need of such analysis for the quality control purposes. Methods: The sample aliquot was mixed with isooctane:chloroform (1:1) and submitted to transesterification; the obtained FAMEs were appropriately diluted using water:isopropanol:acetonitrile (20:50:30) with addition of sodium formate which served as an internal standard, lock mass calibrant and promoted the formation of sodium adducts during electrospray ionization (ESI). The principle of flow injection analysis (FIA) was applied for sample introduction to an ESI - quadrupole- time of flight mass spectrometer (ESI-QTOFMS). The carrier solution was composed of water:isopropanol:acetonitrile (20:50:30). From the acquired MS data, flowgrams of the extracted [M+Na]+ ions were obtained using the following m/z values for individual FAMEs: 293.2451 (C16:0); 315.2295 (C18:3); 317.2451 (C18:2); 319.2608 (C18:1); 321.2764 (C18:0); 335.2557 (C18:1,OH); 349.3077 (C20:0); 377.3390 (C22:0) and m/z 226.9515 for IS. Baseline-subtracted and filtered signals were integrated and the list of peaks intensities was exported to Excel, where calibration functions were obtained and quantification carried out. Gas chromatography with a flame ionization detector (GC-FID) was used as an alternative analytical tool. Results: The calibration detection limits for FAMEs of unsaturated fatty acids were in the range 3.61 - 8.62 μg L-1 and for saturated compounds in the range 8.51 - 82.4 μg L-1 . The results obtained for commercial were in good agreement with GC-FID data; among nine cosmetic oils analyzed, three contained low concentrations of ricinoleic acid (C18:1, OH), indicating adulteration of castor bean oil with other vegetable oils. Conclusion: Application of FIA for the sample introduction to ESI-QTOFMS enabled for reliable determination of FAMEs in cosmetic oils with sampling frequency of thirty per hour as compared to two samples per hour achievable using GC-FID. The proposed procedure is especially well suited for FAMEs of unsaturated fatty acids that are primary components of castor triacylglycerides, and contribute to desirable properties of any cosmetic oil. This article is protected by copyright. All rights reserved.

SEQUENTIAL DETERMINATION OF Zn, Fe, Mg, Ca, Na AND K IN SYNTHETIZED BABASSU FAME BY HIGH RESOLUTION CONTINUUM SOURCE FLAME ATOMIC ABSORPTION SPECTROMETRY

Multivariate optimization of an ultrasound-assisted extraction procedure for the determination of Cu, Fe, Mn, and Zn in plant samples by flame atomic absorption spectrometry

Determination of fatty acid methyl esters in cosmetic castor oils by flow injection - electrospray ionization - high resolution mass spectrometry

Determination of zinc in dried nuts by slotted quartz tube-flame atomic absorption spectrometry (SQT-FAAS) with citric acid-coated magnetic nanoparticle (CAMNP) based solid phase extraction (SPE)

A robotic magnetic nanoparticle solid phase extraction system coupled to flow-batch analyzer and GFAAS for determination of trace cadmium in edible oils without external pretreatment

Determination of Iron, Copper, Zinc, Aluminum, and Chromium in Biodiesel by Flame Atomic Absorption Spectrometry Using a Microemulsion Preparation Method

A new synthesis, characterization and application chelating resin for determination of some trace metals in honey samples by FAAS

Multielemental Analysis of Biodiesel by Dynamic Reaction Cell–Inductively Coupled Plasma-Mass Spectrometry

Evaluation of the use of a reflux system for sample preparation of processed fruit juices and subsequent determination of Cr, Cu, K, Mg, Na, Pb and Zn by atomic spectrometry techniques

DETERMINAÇÃO MULTIELEMENTAR EM AMOSTRAS DE BIODIESEL EMPREGANDO ESPECTROMETRIA DE FLUORESCÊNCIA DE RAIOS-X POR DISPERSÃO DE ENERGIA APÓS EXTRAÇÃO INDUZIDA POR QUEBRA DE EMULSÃO

Comparative analysis of eight esterification methods in the quantitative determination of vegetable oil fatty acid methyl esters (FAME)

Determination of Metallic Element in Soybean Coat by Fermentation-Microwave Digestion-Microwave after Semi-Ashing Plasma Torch Atomic Emission Spectrometry

Sequential and Rapid Determination of Metallic Elements in Monosodium Glutamate by Continuum Source Flame Atomic Absorption Spectrophotometry

Sodium nanoferrite-based solid phase extraction: a green method for the simultaneous determination of cadmium, copper, and lead

Development and validation of a novel analytical method to quantify aflatoxins in baby food samples by employing dispersive solid phase extraction with multi-walled carbon nanotubes

Development, Validation and Application of a Fast Sequential Method for Na, K, Ca and Mg Determination in Hemodialysis Solutions by HR-CS F AAS

Use of Nb(2)O(5)-SiO(2) in an automated on-line preconcentration system for determination of copper and cadmium by FAAS

Elemental Analysis of Dietary Supplements by Microwave-Induced Plasma–Optical Emission Spectrometry (MIP-OES) With Ultrasound-Assisted Extraction (UAE)

A new method for extraction and pre-concentration of the heavy metals using a microemulsion system in winsor II equilibrium and determination by HR-CS AAS

Simultaneous extraction/derivatization for the analysis of sulfite by capillary electrophoresis: A high-throughput reference method to meet the demand of seafood inspection

Multivariate optimization for the determination of cadmium and lead in crude palm oil by graphite furnace atomic absorption spectrometry after extraction induced by emulsion breaking