Abstract:Recently, there has been increased interest in adopting novel sensing technologies for continuously monitoring structural systems. In this respect, micro-electrical mechanical system (MEMS) sensors are widely used in several applications, including structural health monitoring (SHM), in which accelerometric samples are acquired to perform modal analysis. Thanks to their significantly lower cost, ease of installation in the structure, and lower power consumption, they enable extensive, pervasive, and battery-less monitoring systems. This paper presents an innovative high-performance device for SHM applications, based on a low-noise triaxial MEMS accelerometer, providing a guideline and insightful results about the opportunities and capabilities of these devices. Sensor nodes have been designed, developed, and calibrated to meet structural vibration monitoring and modal identification requirements. These components include a protocol for reliable command dissemination through network and data collection, and improvements to software components for data pipelining, jitter control, and high-frequency sampling. Devices were tested in the lab using shaker excitation. Results demonstrate that MEMS-based accelerometers are a feasible solution to replace expensive piezo-based accelerometers. Deploying MEMS is promising to minimize sensor node energy consumption. Time and frequency domain analyses show that MEMS can correctly detect modal frequencies, which are useful parameters for damage detection. The acquired data from the test bed were used to examine the functioning of the network, data transmission, and data quality. The proposed architecture has been successfully deployed in a real case study to monitor the structural health of the Marcus Aurelius Exedra Hall within the Capitoline Museum of Rome. The performance robustness was demonstrated, and the results showed that the wired sensor network provides dense and accurate vibration data for structural continuous monitoring.

An Environmental Monitoring Method of Ancient Buildings Based on the Micro Electro Mechanical System Accelerometers

Study of Building Safety Monitoring by Using Cost-Effective MEMS Accelerometers for Rapid After-Earthquake Assessment with Missing Data

Performance and Measurement Devices for Membrane Buildings in Civil Engineering: A Review

A New Type of MEMS Accelerometer with Up-Tuning Structure

Monitoring the vertical changes of a tidal flat using a MEMS accelerometer array

An Integrated GNSS/MEMS Accelerometer System for Dynamic Structural Response Monitoring under Thunder Loading

Developing and Testing High-Performance SHM Sensors Mounting Low-Noise MEMS Accelerometers

Performance Testing of Micro-Electromechanical Acceleration Sensors for Pavement Vibration Monitoring

Evaluation of low-cost MEMS accelerometers for SHM: frequency and damping identification of civil structures

An Optical Interferometry Based MEMS Accelerometer Applicable to Seismic-Grade Measurement

Development of Triaxial MEMS Digital Accelerometer on Structural Health Monitoring System for Midrise Structures

Accelerometer prototype with combined filtering for noise attenuation using an embedded system and low-cost MEMS sensors for building monitoring

A MEMS-Based Electrochemical Angular Accelerometer With Integrated Plane Electrodes for Seismic Motion Monitoring

Dynamic identification of a masonry structure through a MEMS based monitoring system

Influence of Accelerometer Type on Uncertainties in Recorded Ground Motions and Seismic Damage Assessment

Improved Resolution and Cost Performance of Low-Cost MEMS Seismic Sensor through Parallel Acquisition

Sub-micro-g Resolution Test of Accelerometers Based on Tilt Dynamic Modulation in Gravity Field

In-Depth Analysis of Low-Cost Micro Electromechanical System (MEMS) Accelerometers in the Context of Low Frequencies and Vibration Amplitudes

Prototyping and Validation of MEMS Accelerometers for Structural Health Monitoring—The Case Study of the Pietratagliata Cable-Stayed Bridge

A Seismic-Grade Optical MEMS Accelerometer with Force Feedback Control

Usage of MEMS Capacitive Acceleration Sensors for Structural Monitoring