Abstract:High-reflectance ohmic contacts to p-GaN are the key for Flip-chip ultra-violet light emitting diode (UV-LED) to improve the external quantum efficiency (EQE), so the kinds of metal or alloy film both ohmic contact and the reflector of light are important to choose the appropriate high-reflectance and low-resistance ohmic contact to p-type GaN. The GaN-based LED samples used were grown by Metalorganic Chemical Vapor Deposition (MOCVD). Four different metal films were deposited on the surfaces of p-GaN and annealed Ni/Au alloy. The thickness of these metal films varied from 30 nm to 840 nm. The reflectance and transmittance of the samples were mea- sured by WGS-9 system. The 2θ scans XRD and surface AFM images of the samples were also observed. As results, when the films' thickness under the 130 nm the reflectance of Ag-deposited samples increased with the increasing thickness and the transmittance decreased at wavelength of 400 nm. The reason of the increasing of reflectance is the reduction of the light transmitted through the films. When the films' thickness over 130 nm, the reflectance of Ag-deposited samples decreasing. From the results of XRD and AFM, the metal film formed multi-layers film and the roughness R_a and R_q increased with the increasing thickness. It is suggested that the diffusion of the multi-layers films is the main reason of reduction of reflectance with the films thickness increasing. Other metal films show the same characteristics as the Ag-deposited films. From the result of reflectance, Al and Ag are the suitable candidates for the reflector, but it is reported that the single Al or Ag films don't make good ohmic contacts on p-GaN. So a thin annealed Ni/Au is adopted to interspersed between the Al or Ag reflector and the p-GaN in order to provide efficient hole injection into the device. From the results of reflectance and I-V curves of Ni/Au/Ag and Ni/Au/Al, the I-V characteristics of Ni/Au/Ag and Ni/Au/Al contacts are similar to this of Ni/Au annealed. However the reflectance of Ni/Au/Ag and Ni/Au/Al contacts is three times higher than that of Ni/Au at wavelength of 400 nm. These results demonstrated that Ni/Au/Ag and Ni/Au/Al can be used as high-reflectance and low-resistance p-GaN ohmic contacts for flip-chip UV-LEDs

Evolution of Frenkel defect pairs in β-Ga 2 O 3 thin film with the introduction of oxygen and its application in GaN-based ultraviolet light-emitting diode

Enhanced ultraviolet electroluminescence performance from p-NiO/n-GaN heterojunctions by using i-Ga2O3 as electron blocking layer

Pure ultraviolet light-emitting diode based on the p-NiO/i-NiO/n-GaN structure by magnetron sputtering

Oxygen Vacancies and Local Amorphization Introduced by High Fluence Neutron Irradiation in Β -Ga2o3 Power Diodes

Microstructure Evolution and Electrical Behaviors for High-Performance Cu2O/Zr-Doped β-Ga2O3 Heterojunction Diodes

The preparation of CuO film under different annealing atmospheres and investigation of the excellent electrical and undoped tunable electroluminescence characteristics of Au/i-CuO/n-GaN LED

Effects of implementing dual-step nitrogen ambient for growth and post-deposition annealing of Ga2O3 films sputtered on silicon

Compositions and properties of high-conductivity nitrogen-doped p-type β-Ga2O3 films prepared by the thermal oxidation of GaN in N2O ambient

Electrical and Structural Analysis of β‐Ga2O3/GaN Wafer‐Bonded Heterojunctions with a ZnO Interlayer

Implementation of electron restriction layer in n-AlGaN toward balanced carrier distribution in deep ultraviolet light-emitting-diodes

Ultraviolet Electroluminescence of Zno Based Heterojunction Light Emitting Diode

Pro-environment Cu2O facilitate stable low-wastage ultraviolet p-CuxO/n-GaN LEDs with virtual electron blocking nanolayer

High-reflectance Ohmic Contacts to P-Gan of GaN-based Violet LEDs

A Novel PN junction between Mechanically Exfoliated \b{eta}-Ga2O3 and p-GaN

Effects of UV/O3 and O2 plasma surface treatments on the band-bending of ultrathin ALD-Al2O3 coated Ga-polar GaN

Performance Enhancement of Nitrogen-Polar GaN-based Light-Emitting Diodes Prepared by Metalorganic Chemical Vapor Deposition

Enhancement-mode Ga2O3 FETs with an unintentionally doped (001) β-Ga2O3 channel layer grown by metal-organic chemical vapor deposition

High-quality III-nitride films on conductive, transparent (2̅01)-oriented β-Ga2O3 using a GaN buffer layer

Demonstration of the P-Niox/n-ga2o3 Heterojunction Gate FETs and Diodes with BV2/Ron,sp Figures of Merit of 0.39 GW/cm2 and 1.38 GW/cm2

Excellent electroluminescence and electrical characteristics from p-CuO/i-Ga2O3/n-GaN light-emitting diode prepared by magnetron sputtering

Ultraviolet Electroluminescence From n-ZnO–SiO$_{2}$–ZnO Nanocomposite/p-GaN Heterojunction Light-Emitting Diodes at Forward and Reverse Bias