Abstract:A novel implementation of an analogue low-power, second-order, low-pass filter with tunable quality factor (Q) is presented and discussed. The filter feature is a relatively simple, buffer-based, circuit network consisting of eleven transistors operating in a subthreshold region. Q tuning is accomplished by injecting direct current into a network node, which changes the output resistance of the transistors and, as a result, modifies the filter network's loss, and thus its Q. Q tuning is independent of a filter cut-off frequency (ω0). The filter, with a nominal ω0 of 1 kHz, was fabricated using a 0.18 μm CMOS technology, and features a Q range of 2–11, power consumption of up to 52 nW, and a 59 dB dynamic range when using a 0.5 V supply. The ω0 can be tuned from 0.5 to 2.5 kHz using a traditional method by changing the transistor transconductances, but this process partially affects the quality factor.
engineering, electrical & electronic,computer science, information systems,physics, applied
What problem does this paper attempt to address?
This paper attempts to address the problem of implementing a low-power, second-order, low-pass filter with an adjustable quality factor (Q) in cochlear implant applications. Specifically, the authors designed a nanowatt-level low-pass filter operating at 0.5 V, with a quality factor adjustable between 2 and 11, while maintaining low power consumption (up to 52 nW) and a wide dynamic range (59 dB). The main goal of this filter is to be used in cochlear filter arrays to preprocess acoustic signals, extract components of the amplitude spectrum, and adaptively adjust the sensitivity of signal paths in various frequency bands, thereby improving the dynamic range and intelligibility of sounds, especially in the presence of noise and external interference.
### Background of the Paper
1. **Hearing Aids and Speech Recognition Devices**: These devices require adjustable filters to simulate the characteristics of the human cochlea, in order to preprocess acoustic signals, extract components of the amplitude spectrum, and adaptively adjust the sensitivity of signal paths in various frequency bands.
2. **Low Power Consumption Requirement**: Particularly for implantable hearing aids, reducing power consumption and supply voltage is crucial, as the implant itself contains a small energy storage device and relies on periodic energy replenishment for long-term operation.
### Design Features
1. **Low Power Consumption**: Significant power reduction is achieved by using MOS transistors operating in the subthreshold region.
2. **Adjustable Quality Factor**: By injecting DC current into network nodes, the output resistance of the transistors is altered, thereby modifying the loss of the filter network and adjusting the quality factor. This process is independent of the filter cutoff frequency (ω0).
3. **Simple Circuit Structure**: The filter consists of a buffer-based circuit network composed of 11 transistors, which is relatively simple.
### Experimental Results
1. **Quality Factor Adjustment**: Experimental results show that the quality factor can be adjusted from 6.7 dB (2.16) to 21.4 dB (11.74), with no deviation in the cutoff frequency (1 kHz).
2. **Frequency Adjustment Range**: By changing the bias current (IBIAS), the cutoff frequency can be adjusted from 500 Hz to 2.5 kHz, and the change in quality factor can be compensated by appropriately adjusting IQ.
3. **Noise Performance**: The total noise is 70 µV RMS, and the signal-to-noise ratio (S/N) is 59.7 dB.
### Summary
This paper presents a low-power, second-order, low-pass filter with an adjustable quality factor suitable for cochlear implant applications. The filter demonstrates good performance under low voltage and low power conditions, meeting the needs of cochlear filter arrays.