Advanced process design of subcooling re-liquefaction system considering storage pressure for a liquefied CO 2 carrier

Jaejun Lee,Heechang Son,Juyoung Oh,Taejong Yu,Hyeonuk Kim,Youngsub Lim
DOI: https://doi.org/10.1016/j.energy.2024.130556
IF: 9
2024-02-16
Energy
Abstract:Because carbon capture and storage methods are considered greenhouse gas reduction technologies, demand for a large liquefied CO 2 (LCO 2 ) carrier to transport captured CO 2 to storage sites has arisen. To prevent the emission of boil-off CO 2 gas during transport, a CO 2 re-liquefaction system would be required. This study suggests a new type of LCO 2 subcooling re-liquefaction system for an LCO 2 carrier and demonstrates its effectiveness by comparing its performance with that of conventional re-liquefaction systems considering LCO 2 storage pressure. The results show that the suggested LCO 2 subcooling system has lower specific energy consumption than that of conventional LCO 2 re-liquefaction systems, even with a simpler configuration. At 15 bar of storage pressure, the LCO 2 subcooling system has a lower specific energy consumption of 176.91 kJ/kgCO2 , which is 18.2 and 5.3 % lower than that of the Linde–Hampson cycle and vapor-compression refrigeration cycle using NH 3 as a refrigerant, respectively. Additionally, economic benefits can be obtained because the boil-off CO 2 compressor is not required in an LCO 2 subcooling system. Finally, considering CO 2 re-liquefaction performance and the design constraints of the LCO 2 carrier, 15 bar LCO 2 storage conditions with a subcooling system are considered the most economical LCO 2 carrier design.
energy & fuels,thermodynamics
What problem does this paper attempt to address?