Abstract:The calculation reliability of pressure drop and gas–solid drag force in horizontal dilute phase pneumatic conveying strongly depends on the accuracy of gas–solid velocity correlation. However, there are limited studies on the solid velocity in horizontal dilute phase pneumatic conveying and it is important to further validate suitability of existing correlation of gas–solid velocity, especially for fine particles (such as pulverized coal). Consequently, in this paper, a negative pressure pneumatic conveying test rig is set up and two kinds of powders with different sizes are adopted. Optical fiber probe (OFP) was used to measure the volumetric solid concentration and particle velocity. The volumetric solid concentration was also calculated by using the measured particle velocity. The results show that the solid concentrations obtained by the two methods have good agreement, and discrepancy is within ±20%. It was found the particle velocities are different in the upper and lower part of the cross-section in the horizontal pipe. However, the difference is generally no more than 2m/s. The velocity difference will decrease with the increasing gas velocity, and increases with the solid mass flow rate. In the experimental condition of 0.06mm<ds<0.35mm, 1400kg/m3<ρs<2600kg/m3, the implicit correlation based on Yang's Unified Theory gives the best prediction of particle velocity among existing studies but still with noticeable discrepancy with the comparison of the present experimental data. By modifying the solid friction factor, an improved correlation of the particle velocity was obtained, which agrees better with the experimental data given in the present and literature studies.

Relationship between the flow regime characteristics and pressure signal in dense phase pneumatic conveying

Flow Regime Identification in Horizontal Pneumatic Conveying by Nonintrusive Acoustic Emission Detection

Multi-Scale Analysis of Acoustic Emission Signals in Dense-Phase Pneumatic Conveying of Pulverized Coal at High Pressure

Flow Regime Identification Using Pressure Fluctuation Signals in an Aerated Vessel Stirred

Measurement and Analysis of Flow Regimes Transition by Acoustic and Electrostatic Signals in Vertical Pneumatic Conveying

Acoustic Analysis of Particle-Wall Interactions of Plug Flow in Vertical Pneumatic Conveying

Acoustic Analysis of Particle–Wall Interaction and Detection of Particle Mass Flow Rate in Vertical Pneumatic Conveying

Study on the Nature of Pressure Signals in a Bubbling Fluidized Bed

Numerical simulations on the flow regime characteristics of horizontal pneumatic conveying using CFD-DEM

Flow Regime Transition and Liquid Distribution in a 3D Concurrent Downflow Three-Phase Moving Bed

Investigation of Particle Flow Behaviors in a Simplified Downcomer of Multistage Fluidized Bed

Research on the Pneumatic Conveying Characteristics of Fly Ash in the Power Station

Modeling and analysis of flow regimes in hydraulic conveying of coarse particles

Flow regimes detection in a quasi-2D granular chute flow based on PTV technique

Flow Patterns of Pneumatic Conveying of Pulverized Coal in Horizontal Pipes for Pressurized Conditions

Wavelet Analysis of Pressure Fluctuation Signals in a Gas-Solid Fluidized Bed

Influence of the Replenishment Methods of the Sending Tanks on Pneumatic Conveying Characteristics

Time-series Analysis of the Characteristic Pressure Fluctuations in a Conical Fluidized Bed with Negative Pressure

Analysis of pressure fluctuations in pneumatic conveying systems via pressure sensors – A review

Experimental study on the solid velocity in horizontal dilute phase pneumatic conveying of fine powders

COMPLEX STUDY OF FLOW REGIME CHARACTER AND IDENTIFICATION IN THE GAS-SOLID FLUIDIZED BED