Abstract:The precise measurement of weak magnetic fields by using high-sensitivity magnetometers is not only widely used, but also promotes the development of many research fields. The magnetic field measurement capability of the magnetometer determines the potential and scope of its application, which means that research on its magnetic field measurement capability is essential.In this work, we develop a rubidium-xenon vapor cell atomic magnetometer. The cell filled with 5-torr 129Xe, 250-torr N2 and a droplet of enriched 87Rb is placed in the center of a five-layer magnetic shield with four sets of inner coils to control the internal magnetic field environment. In the cell, 129Xe is polarized by spin exchange collisions with 87Rb atoms, which are pumped with a circularly polarized laser beam at the D1 transition. If magnetic fields or pulses are applied to the cell, the polarization state of 87Rb and 129Xe will change and evolve, whose evolution process can be described by a pair of Bloch equations. The analysis of the Bloch equations indicates that the rubidium-xenon vapor cell atomic magnetometer can measure magnetic fields by two different methods. The magnetic field measurement capabilities of the two methods are experimentally calibrated respectively. The first method is to measure the alternating current (AC) magnetic fields by measuring the influence of the external magnetic fields on the polarization of the 87Rb atoms. The experimental results show that the sensitivity of the AC magnetic field measurement is about \begin{document}$1.5\;{{{\rm{pT}}} / {\sqrt {{\rm{Hz}}} }} $\end{document} in a frequency range of 2100 Hz, and the bandwidth is about 2.8 kHz. The second method is to measure the static magnetic fields by measuring the Larmor frequency of the hyperpolarized 129Xe in the cell. Considering that its measurement accuracy is limited by the relaxation of the hyperpolarized 129Xe, the transverse and longitudinal relaxation time are measured to be about 20.6 s and 21.5 s, respectively. Then, the experimental calibration results indicate that the static magnetic field measurement precision is about 9.4 pT and the measurement range exceeds 50 μT, which prove that the static magnetic field measurement can still be performed under geomagnetic field (50 μT). The rubidium-xenon vapor cell atomic magnetometer enables the measurement of AC magnetic fields and static magnetic fields in the same system. Compared with the spin exchange relaxation free (SERF) atomic magnetometer, the rubidium-xenon vapor cell atomic magnetometer has some unique advantages. For AC magnetic field measurement, it has a wider frequency range. For static magnetic field measurement, it can be performed under geomagnetic field and can give the magnetic field measurement value without using the calibration parameters of the system. These characteristics make the rubidium-xenon vapor cell atomic magnetometer have broad application prospects. It is expected to be applied to geomagnetic surveys, basic physics and other aspects of research.

Magnetic field generator for the calibration of magnetometers and electromagnetic compatibility (EMC) and electromagnetic interference (EMI) compliance

A Broadband NMR Magnetometer System with Field Searching and Automatic Tuning Function

Magnetic Calibration System With Interference Compensation

A Magnetic Sensor Calibration System Based on a Closed-Loop Tri-Axial Field Simulator

Optimized and Standardized Circular-Coil Systems for Homogeneous Magnetic Field Generation

Measurement of induced currents in radio frequency magnetic fields based on near field antenna perturbations

In Situ Calibration of Magnetic Coil System Using Ellipticity-Induced Bell-Bloom Magnetometer

A Method Based on Measured Boundary Conditions for Reconstructing the Magnetic Field Distribution of an Electromagnetic Mechatronic System

A Comprehensive Calibration Method for Non-Orthogonal Error and Scale Factor Error of Triaxial Helmholtz Coil.

The sub-millimetre non-uniformity measurement of residual and coil-generated field in the magnetic shield using atomic vapor cell

A New System for Calibrating a Pulsed Field Magnetometer

Measuring magnetic field coil constants based on atomic magnetometry and fluxgate magnetometry

In Situ Calibration of Magnetic Field Coils Using Parametric Resonance in Optically-pumped Magnetometers

An Efficient Calibration Method for SQUID Measurement System Using Three Orthogonal Helmholtz Coils

Magnetic Field Stabilization for Magnetically Shielded Volumes by External Field Coils

Design and Implementation of Automatic Calibration of a Magnetoresistance Effect-Based Transient Magnetic Field Recorder

Calibration of Magnetic Field Measurement Capability of Rubidium-Xenon Vapor Cell Atomic Magnetometer

Design and Development of Distributed Magnetic Measurement System Based on Hall Array

Analysis and Design of an Immunity Test Platform Against DC and Power-Frequency Magnetic Field

Calibration technique for rotating PCB coil magnetic field sensors

A Dumbbell-Shaped Hybrid Magnetometer Operating in DC-10 Khz.