Abstract:Emerging organic solar cells based on a ternary strategy is one of the most effective methods for improving the blend film morphology, absorption ability, and device performances. On the other hand, this strategy has had very limited success in all-polymer solar cells (all-PSCs) because of the scarcity of new polymers and the challenges faced during third component optimization. Herein, highly efficient ternary all-PSCs were developed from siloxane-functionalized side chains with a wide-band-gap (Eg) polymer, Si-BDT, which is blended with a medium and ultra-narrow Eg polymer donor and acceptor, PTB7-Th, and DCNBT-TPIC. An impressive power conversion efficiency (PCE) of 13.45% was achieved in the ternary all-PSCs [PTB7-Th(0.6):Si-BDT(0.4):DCNBT-TPIC(0.6)] with the addition of 0.4 wt equivalent Si-BDT into binary all-PSCs [PTB7-Th(1):DCNBT-TPIC(0.6) PCE of 10.11%]. In contrast, the binary all-PSCs with a Si-BDT(1):DCNBT-TPIC(0.6) active layer only exhibited a good PCE of 9.92%. More importantly, the siloxane-functionalized side chains increase the light-absorption ability, carrier mobility, blend miscibility, and film morphology in ternary devices compared to those of the binary devices. Hence, exciton dissociation, charge carrier transport, and suppressed recombination properties were facilitated. In the presence of Si-BDT, both binary and ternary all-PSCs PCEs are significantly improved. Indeed, 13.45% PCE is one of the best values reported for all-PSCs except for those based on polymerized small molecule acceptors. In addition, the ternary all-PSCs showed excellent environmental and thermal stabilities with 95 and 84% of the initial PCE retained after 900 and 500 h, respectively. These results offer effective device engineering, providing a new avenue for improving the device performance in ternary all-PSCs.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsami.1c20542.Additional text describing experimental details (materials and measurements and characterization of the all-PSCs), SCLC, UV–vis absorption spectra, UPS analysis, efficiency histograms, J–V curves, PL spectra, EDS element mapping, contact angle, GIXRD study, and recent publications based on ternary all-PSCs (PDF)This article has not yet been cited by other publications.

Over 19.1% efficiency for sequentially spin-coated polymer solar cells by employing ternary strategy

Smart Ternary Strategy in Promoting the Performance of Polymer Solar Cells Based on Bulk‐Heterojunction or Layer‐By‐Layer Structure

Efficient Dual Mechanisms Boost the Efficiency of Ternary Solar Cells with Two Compatible Polymer Donors to Exceed 19

Facile Strategy for Third Component Optimization in Wide-Band-Gap π-Conjugated Polymer Donor-Based Efficient Ternary All-Polymer Solar Cells

Ternary Polymer Solar Cells Enabled Using Two Donor Polymers with Broad Absorption and Cascade LUMO Levels

Ternary Polymer Solar Cells Based-on Two Polymer Donors with Similar HOMO Levels and an Organic Acceptor with Absorption Extending to 850 Nm

Ternary All‐Polymer Solar Cells with Efficiency up to 18.14% Employing a Two‐Step Sequential Deposition

Ternary Strategy Enabling High‐Performance Organic Solar Cells with Optimized Film Morphology and Reduced Nonradiative Energy Loss

Ternary Polymer Solar Cells with High Efficiency of 14.24% by Integrating Two Well‐Complementary Nonfullerene Acceptors

High-Performance Ternary Nonfullerene Polymer Solar Cells with Both Improved Photon Harvesting and Device Stability.

Ternary All-Polymer Solar Cells with 8.5% Power Conversion Efficiency and Excellent Thermal Stability.

9.0% Power Conversion Efficiency from Ternary All-Polymer Solar Cells

Synergistically minimized nonradiative energy loss and optimized morphology achieved via the incorporation of small molecule donor in 17.7% efficiency ternary polymer solar cells

Over 18% efficiency ternary all-polymer solar cells with high photocurrent and fill factor

Enhanced Photovoltaic Performances Via Ternary Blend Strategy Employing a Medium-Bandgap D-A Type Alternating Copolymer As the Single Donor

Designing a Highly Crystalline Polymer Donor with Alkylsilyl and Fluorine Substitution to Achieve Efficient Ternary Organic Solar Cells

Achieving 19.72% Efficiency in Ternary Organic Solar Cells through Electrostatic Potential‐Driven Morphology Control

Ternary Strategy Enables Non‐Halogenated Solvent‐Processed All‐Polymer Solar Cells with High Efficiency Over 18%

Realization of Performance Enhancement in Ternary Polymer Solar Cells by Broad Absorption, Efficient Energy Transfer, and Balanced Charge Carrier Mobility

Alloy-like ternary polymer solar cells with over 17.2% efficiency

Ternary Nonfullerene Polymer Solar Cells with a Power Conversion Efficiency of 11.6% by Inheriting the Advantages of Binary Cells