Abstract:Emerging organic solar cells based on a ternary strategy is one of the most effective methods for improving the blend film morphology, absorption ability, and device performances. On the other hand, this strategy has had very limited success in all-polymer solar cells (all-PSCs) because of the scarcity of new polymers and the challenges faced during third component optimization. Herein, highly efficient ternary all-PSCs were developed from siloxane-functionalized side chains with a wide-band-gap (Eg) polymer, Si-BDT, which is blended with a medium and ultra-narrow Eg polymer donor and acceptor, PTB7-Th, and DCNBT-TPIC. An impressive power conversion efficiency (PCE) of 13.45% was achieved in the ternary all-PSCs [PTB7-Th(0.6):Si-BDT(0.4):DCNBT-TPIC(0.6)] with the addition of 0.4 wt equivalent Si-BDT into binary all-PSCs [PTB7-Th(1):DCNBT-TPIC(0.6) PCE of 10.11%]. In contrast, the binary all-PSCs with a Si-BDT(1):DCNBT-TPIC(0.6) active layer only exhibited a good PCE of 9.92%. More importantly, the siloxane-functionalized side chains increase the light-absorption ability, carrier mobility, blend miscibility, and film morphology in ternary devices compared to those of the binary devices. Hence, exciton dissociation, charge carrier transport, and suppressed recombination properties were facilitated. In the presence of Si-BDT, both binary and ternary all-PSCs PCEs are significantly improved. Indeed, 13.45% PCE is one of the best values reported for all-PSCs except for those based on polymerized small molecule acceptors. In addition, the ternary all-PSCs showed excellent environmental and thermal stabilities with 95 and 84% of the initial PCE retained after 900 and 500 h, respectively. These results offer effective device engineering, providing a new avenue for improving the device performance in ternary all-PSCs.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsami.1c20542.Additional text describing experimental details (materials and measurements and characterization of the all-PSCs), SCLC, UV–vis absorption spectra, UPS analysis, efficiency histograms, J–V curves, PL spectra, EDS element mapping, contact angle, GIXRD study, and recent publications based on ternary all-PSCs (PDF)This article has not yet been cited by other publications.

Ternary strategy: An analogue as third component reduces the energy loss and improves the efficiency of polymer solar cells

Ternary Strategy Enabling High‐Performance Organic Solar Cells with Optimized Film Morphology and Reduced Nonradiative Energy Loss

Enhanced short circuit current density and efficiency of ternary organic solar cells by addition of a simple copolymer third component

Ternary Solar Cells Via Ternary Polymer Donors and Third Component PC71BM to Optimize Morphology with 13.15% Efficiency

Enhanced Photovoltaic Performances Via Ternary Blend Strategy Employing a Medium-Bandgap D-A Type Alternating Copolymer As the Single Donor

Facile Strategy for Third Component Optimization in Wide-Band-Gap π-Conjugated Polymer Donor-Based Efficient Ternary All-Polymer Solar Cells

Smart Ternary Strategy in Promoting the Performance of Polymer Solar Cells Based on Bulk‐Heterojunction or Layer‐By‐Layer Structure

Realization of Performance Enhancement in Ternary Polymer Solar Cells by Broad Absorption, Efficient Energy Transfer, and Balanced Charge Carrier Mobility

Achieving 19.72% Efficiency in Ternary Organic Solar Cells through Electrostatic Potential‐Driven Morphology Control

A Near-Infrared Photoactive Morphology Modifier Leads to Significant Current Improvement and Energy Loss Mitigation for Ternary Organic Solar Cells

Efficient Ternary Organic Solar Cells with a New Electron Acceptor Based on 3,4-(2,2-Dihexylpropylenedioxy)thiophene

Efficient Dual Mechanisms Boost the Efficiency of Ternary Solar Cells with Two Compatible Polymer Donors to Exceed 19

Ternary Polymer Solar Cells Based-on Two Polymer Donors with Similar HOMO Levels and an Organic Acceptor with Absorption Extending to 850 Nm

Ternary All-Polymer Solar Cells with 8.5% Power Conversion Efficiency and Excellent Thermal Stability.

Simultaneous Performance and Stability Improvement of Ternary Polymer Solar Cells Enabled by Modulating the Molecular Packing of Acceptors

Molecular Interactions Regulation by Adding a Third Component with High Miscibility Suppresses the Energetic Disorder and Reduces Energy Loss for Efficient Ternary Solar Cells

Ternary Strategy Enables Non‐Halogenated Solvent‐Processed All‐Polymer Solar Cells with High Efficiency Over 18%

Using Ternary Blend As a Strategy to Improve the Driving Force for Charge Transfer and Facilitate Electron Transport in Polymer Solar Cells

High-Performance Ternary Polymer Solar Cells Enabled by Using a Branched Polymer As the Guest Donor

Molecular interaction regulation by adding a third component with high miscibility suppresses the energetic disorder and reduces energy loss for efficient ternary solar cells

Ternary Organic Solar Cells with Minimum Voltage Losses