Abstract:Portable sensor systems are usually based on microcontrollers and/or Field-Programmable Gate Arrays (FPGAs) that are interfaced with sensors by means of an Analog-to-Digital converter (ADC), either integrated in the computing device or external. An alternative solution is based on the direct connection of the sensors to the digital input port of the microcontroller or FPGA. This solution is particularly interesting in the case of devices not integrating an internal ADC or featuring a small number of ADC channels. In this paper, a technique is presented to directly interface sensors with analog voltage output to the digital input port of a microcontroller or FPGA. The proposed method requires only a few passive components and is based on the measurements of the duty cycle of a digital square-wave signal. This technique was investigated by means of circuit simulations using LTSpice and was implemented in a commercial low-cost FPGA device (Gowin GW1NR-9). The duty cycle of the square-wave signal features a good linear correlation with the analog voltage to be measured. Thus, a look-up table to map the analog voltage values to the measured duty cycle is not required with benefits in terms of memory occupation. The experimental results on the FPGA device have shown that the analog voltage can be measured with a maximum accuracy of 1.09 mV and a sampling rate of 9.75 Hz. The sampling rate can be increased to 31.35 Hz and 128.31 Hz with an accuracy of 1.61 mV and 2.68 mV, respectively.

Effective number of resolution bits in direct sensor-to-microcontroller interfaces

An All-Digital CMOS Temperature Sensor with a Wide Supply Voltage Range.

An Energy-Efficient 15-Bit Capacitive-Sensor Interface Based On Period Modulation

A measurement method for lossy capacitive relative humidity sensors based on a direct sensor-to-microcontroller interface circuit

Uncertainty reduction techniques in microcontroller-based time measurements

A 14-B BW /power Scalable Sensor Interface with a Dynamic Bandgap Reference

A 1-V Diode-Based Temperature Sensor with a Resolution FoM of 3.1pj•k2 in 55nm CMOS

A 1.2V Self-Referenced Temperature Sensor with a Time-Domain Readout and a Two-Step Improvement on Output Dynamic Range

Improved Single-Element Resistive Sensor-to-Microcontroller Interface

An energy-efficient 15-bit capacitive sensor interface.

Power-Efficiency Evolution of Capacitive Sensor Interfaces

18.2 A 16Fj/conversion-Step Time-Domain Two-Step Capacitance-to-Digital Converter

Energy-Efficient Capacitive Sensor Interfaces

A Capacitance-To-Digital Converter for MEMS Sensors for Smart Applications

A 72-Channel Resistive-and-Capacitive Sensor-Interface Chip With Noise-Orthogonalizing and Pad-Sharing Techniques

A 1770- $\mu$ M 2 Leakage-Based Digital Temperature Sensor with Supply Sensitivity Suppression in 55-Nm CMOS

A 9.7Fj/conv.-Step Capacitive Sensor Readout Circuit with Incremental Zoomed Time Domain Quantization.

An Energy-Efficient Capacitive Sensor Readout Circuit With Zoomed Time-Domain Quantization

Digital micro-capacitance measuring system and application

A Combined Temperature and Capacitance Sensor Interface

Efficient and Accurate Analog Voltage Measurement Using a Direct Sensor-to-Digital Port Interface for Microcontrollers and Field-Programmable Gate Arrays