Abstract:Non-equiatomic high entropy alloys (HEAs) and medium entropy alloys (MEAs) are expected to have the potential to exhibit good mechanical properties due to abundant composition designs compared to equiatomic alloys. It has been reported that an equiatomic CoCrNi MEA shows better strength-ductility balance than CoCrFeMnNi HEA, and there is a possibility that the mechanical properties can be further improved by changing chemical composition. Among the constituent elements, cobalt (Co) has the effect of decreasing stacking fault energy (SFE). In this study, we clarified the effect of Co-content on mechanical properties of non-equiatomic Co–Cr–Ni MEAs with different amounts of Co through investigating deformation behaviors and deformation microstructures. Cox(CrNi)(100−x) (x = 20 (Co20), 40 (Co40), 60 (Co60) at%) MEAs were processed to very high plastic strains by high-pressure torsion (HPT) and subsequently annealed under proper conditions to obtain FCC single-phase and uniform fine grain sizes. Mechanical properties of the specimens with fully recrystallized microstructures were characterized by tensile tests at room temperature. Their deformed microstructures at different tensile strain levels were observed by electron microscopy. The result of the tensile tests showed that the work-hardening rate was enhanced with increasing the Co-content although early fracture before reaching plastic instability condition occurred in Co60. Planar slip of dislocations and deformation twinning were observed in Co20 (SFE = 30 mJ/m2), while, in addition to them, deformation-induced martensitic transformation to HCP ε-martensite was observed in Co40 having lower SFE (SFE = 10 mJ/m2), leading to higher work-hardening rate. By increasing Co-content (decreasing SFE) further, phase fraction of ε-martensite greatly increased in Co60 (SFE = 0 mJ/m2) compared with Co40, and early fracture occurred due to stress concentration at intersects between martensite and grain boundaries. The present results suggested that the mechanical properties of the present materials could be effectively designed by controlling the SFE.

Effect of Mn element on shock response in CoCrFeNiMn x High Entropy Alloys

Shock-Induced Deformation and Spallation in CoCrFeMnNi High-Entropy Alloys at High Strain-Rates

Effect of manganese on mechanical properties and deformation mechanism of CoCrFeNi high entropy alloys

Molecular dynamics analysis of the low-temperature shock behavior of the CoCrFeMnNi high-entropy alloy

Effect of crystallographic orientations on shock-induced plasticity for CoCrFeMnNi high-entropy alloy

Effects of Mn addition on mechanical properties, fracture surface, and electrochemical corrosion resistance of CoCrFeNiAl high-entropy alloys

Effect of lattice distortion and nanovoids on the shock compression behavior of (Co-Cr-Cu-Fe-Ni) high entropy alloy

Effect of Mn Content on Crystallization Behaviors and Magnetic Properties of FeCoNiBMn High-Entropy Amorphous Alloys

On the martensitic transformation in Fe$_{x}$Mn$_{80-x}$Co$_{10}$Cr$_{10}$ high-entropy alloy

Theoretical Analysis of Stacking Fault Energy, Elastic Properties, Electronic Properties, and Work Function of MnxCoCrFeNi High-Entropy Alloy

Effect of Mn Contents on the Phase Transition of the High Entropy Alloy Prepared by Laser Cladding

Unraveling Anisotropy in Crystalline Orientation under Shock-Induced Dynamic Responses in High-Entropy Alloy Co25Ni25Fe25Al7.5Cu17.5

Effects of Transient Thermal Shock on the Microstructure and Mechanical Properties of CoCrFeNiMn High-Entropy Alloy Coatings

Effect of Mo Content on Microstructure and Mechanical Properties of CoCrFeNi Series High-entropy Alloys

Effect of Cobalt-Content on Mechanical Properties of Non-Equiatomic Co–Cr–Ni Medium Entropy Alloys

Molecular simulation of microstructure evolution and plastic deformation of nanocrystalline CoCrFeMnNi high-entropy alloy under tension and compression

Size effect, critical resolved shear stress, stacking fault energy, and solid solution strengthening in the CrMnFeCoNi high-entropy alloy

Mechanical properties and fracture mechanism of as-cast MnFeCoCuNi high-entropy alloys

Dynamic behavior of CrMnFeCoNi high-entropy alloy in impact tension

Microstructure and Properties of FeCrMnxAlCu High-Entropy Alloys and Coatings

Effects of high entropy and twin boundary on the nanoindentation of CoCrNiFeMn high-entropy alloy: A molecular dynamics study