Research and Development of PCB for Switching Power Supply

Wenjie Zhang,Renbo Xu,Jinfeng Li

DOI: https://doi.org/10.2991/ICMCS-18.2018.111

2018-10-01

Abstract:As the power source of the electronic equipment, the switch power is developed in the direction of efficiency, high power factor and low cost, and the core component high voltage power switch device is the main factor affecting the efficiency and reliability of the switching power supply. Therefore, it has practical significance for the design of the power supply circuit and the research of high voltage power devices. China has made rapid progress in the development of power devices, but there is a big gap between domestic production technology and foreign advanced level. Most businesses still use micron level technology lines, products are mainly in the middle and low ends, and foreign devices have occupied a huge market share because of the advantages of excellent performance and independent property rights. Therefore, the research and development of new device structure and its control of process flow are of practical significance. This paper focuses on the characteristics and main parameters of semiconductor lighting, and the design of PCB. Research Status and Development Trend First, high frequency and high power: the volume of the switching power supply is inversely proportional to the square root of the working frequency. On the premise of the same power capacity, the switching frequency can be greatly reduced. PWM and PFM chips with frequencies up to 1MHz have been developed abroad. The Power Integrations Inc in the United States is the first in the world to develop a successful three terminal isolated PWM type and turn off the power supply. After that, TOPSwitch, TOPSwitch-II, TOPSwitch-Fx, TOPSwitch-GX, PeakSwitch, LinkSwitch and other series of products have been introduced. PAM in China has successfully developed a high-power power supply with a single power of 48kW and has been successfully applied to the electroplating industry by using full bridge phase shifted zero voltage switching technology. Using multiple modules parallel technology, Li Jinzhi successfully developed a high power switching power supply with a whole power of 150kW, in which the power of a single module is also 45kW, and it is successfully applied to the electrolysis power supply. Secondly, the efficiency is high and the performance is good: because the power of the switching power supply is "open" and "shut", the current and voltage waveforms in the opening and closing process are overlapped and the switching loss is produced, which can not be ignored. Therefore, under the trend of high frequency development, soft switching technology emerges as the times require. At present, it is mainly through resonance to create zero voltage or zero current to open and turn off the switch tube to reduce the overlap of current waveform and voltage waveform, thus effectively reducing the loss and current and voltage stress of the switch tube, making the efficiency of the switching power supply more effective. It is necessary to use less devices as possible to improve the integration. This method not only reduces the volume of the whole machine, but also facilitates the design and manufacture of the whole machine. Again, high pressure and high reliability: the development of switch power has always been closely related to the development of semiconductor devices, high frequency realization, the need for corresponding high performance semiconductor devices. At present, a bipolar transistor is used as a switching power supply for a power tube. The switching frequency can reach dozens of kHz, 8th International Conference on Management and Computer Science (ICMCS 2018) Copyright © 2018, the Authors. Published by Atlantis Press. This is an open access article under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/). Advances in Computer Science Research, volume 77

Engineering,Computer Science