Abstract:Balancing interfacial stability and Li+ transfer kinetics through surface engineering is a key challenge in developing high-performance battery materials. Although conformal coating enabled by atomic layer deposition (ALD) has shown great promise in controlling impedance increase upon cycling by minimizing side reactions at the electrode–electrolyte interface, the coating layer itself usually exhibits poor Li+ conductivity and impedes surface charge transfer. In this work, we have shown that by carefully controlling postannealing temperature of an ultrathin ZrO2 film prepared by ALD, Zr4+ surface doping could be achieved for Ni-rich layered oxides to accelerate the charge transfer yet provide sufficient protection. Using single-crystal LiNi0.6Mn0.2Co0.2O2 as a model material, we have shown that surface Zr4+ doping combined with ZrO2 coating can enhance both the cycle performance and rate capability during high-voltage operation. Surface doping via controllable postannealing of ALD surface coating layer reveals an attractive path toward developing stable and Li+-conductive interfaces for single-crystal battery materials.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acs.nanolett.0c03778?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acs.nanolett.0c03778</a>.Quasi in situ X-ray photoelectron spectroscopy (XPS) characterizations of Zr 3d and Ni 2p (Figure S1), XPS characterizations of O 1s (Figure S2), energy-dispersive spectroscopy (EDS) mapping of 50-ZrO2-700 °C-NCM (Figure S3), cross-sectional scanning electron microscopy (SEM) images of SC-NCM and 5-ZrO2-NCM electrode collected after 50 cycles (Figure S4), reproducible cycle and rate performance of 5-ZrO2-500 °C-NCM (Figure S5), XPS characterizations of F 1s (Figure S6), SEM characterizations of SC-NCM; 5-ZrO2-NCM; 5-ZrO2-500 °C-NCM; 5-ZrO2-700 °C-NCM after 50 cycles (Figure S7), cycle stability of NCM cathodes at 1 C (180 mA/g) in this study compared to literature reports (Table S1) (<a class="ext-link" href="/doi/suppl/10.1021/acs.nanolett.0c03778/suppl_file/nl0c03778_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Precursor-oriented ultrathin Zr-based gradient coating on Ni-riched cathodes

Utilizing Diverse Functions of Zirconium to Enhance the Electrochemical Performance of Ni-Rich Layered Cathode Materials

Realizing Superior Cycling Stability of Ni-Rich Layered Cathode by Combination of Grain Boundary Engineering and Surface Coating

A Three in One Strategy to Achieve Zirconium Doping, Boron Doping, and Interfacial Coating for Stable LiNi 0.8 Co 0.1 Mn 0.1 O 2 Cathode

Surface Atomic Rearrangement with High Cation Ordering for Ultra-Stable Single-Crystal Ni-Rich Co-Less Cathode Materials

Stabilizing surface chemical and structural Ni-rich cathode via a non-destructive surface reinforcement strategy

Insights into the precursor specific surface area for engineering Co-free Ni-rich cathodes with tailorable properties

A Three in One Strategy to Achieve Zirconium Doping, Boron Doping, and Interfacial Coating for Stable LiNi0.8Co0.1Mn0.1O2 Cathode

Enabling Structure/Interface Regulation for High Performance Ni‐Rich Cathodes

Stabilizing high-Ni cathodes with gradient surface Ti-enrichment

Boosting cell performance of LiNi0.8Co0.1Mn0.1O2 cathode material via structure design

Precise Regulation of Particle Orientation for Ni-Rich Cathodes with Ultra-Long Cycle Life

Integrated Surface Modulation of Ultrahigh Ni Cathode Materials for Improved Battery Performance

Reducing structural degradation of high-voltage single-crystal Ni-rich cathode through in situ doping strategy

Simultaneous Enhancement of Interfacial Stability and Kinetics of Single-Crystal LiNi 0.6 Mn 0.2 Co 0.2 O 2 through Optimized Surface Coating and Doping

Surface enrichment and diffusion enabling gradient-doping and coating of Ni-rich cathode toward Li-ion batteries

Fabricating a thin gradient surface layer to enhance the cycle stability of Ni-rich cathode materials

Enhancing the Electrochemical Performance of Ni-Rich Layered Oxide Cathodes by Combination of the Gradient Doping and Dual-Conductive Layers Coating

Enhancing the structural stability of Ni-rich layered oxide cathodes with a preformed Zr-concentrated defective nanolayer.

Highly Stabilized Ni‐Rich Cathodes Enabled by Artificially Reversing Naturally‐Formed Interface

Nanoscale operation of Ni-Rich cathode surface by polycrystalline solid electrolytes Li3.2Zr0.4Si0.6O3.6 coating