DAS for 2D MASW Imaging: A Case Study on the Benefits of Flexible Sub-Array Processing

Michael B S Yust,Brady R Cox,Joseph P Vantassel,Peter G Hubbard

DOI: https://doi.org/10.1093/gji/ggae122

IF: 3.352

2024-03-27

Geophysical Journal International

Abstract:Summary Distributed acoustic sensing (DAS) is a relatively new technology for recording the propagation of seismic waves, with promising applications in both engineering and geophysics. DAS's ability to simultaneously collect high spatial resolution waveforms over long arrays suggests that it is well-suited for near-surface imaging applications such as 2D MASW (multichannel analysis of surface waves), which require, at a minimum, long, linear arrays of single-component receivers. The 2D MASW method uses a large number of sensor sub-arrays deployed along a linear alignment to produce 1D shear-wave velocity (VS) profiles beneath each sub-array. The 1D VS profiles are then combined to form a pseudo-2D VS image beneath the entire linear alignment that can be used for the purpose of identifying and characterizing lateral variations in subsurface layering. Traditionally, 2D MASW is conducted using arrays consisting of either 24 or 48 geophones. While additional receivers could easily be incorporated into the testing configuration, it is rare for researchers and practitioners to have access to greater numbers of seismographs and geophones. When a limited number of geophones are available for deployment, there is a need to pre-determine the geophone spacing and sub-array length prior to field data acquisition. Studies examining how the choice of sub-array geometry impacts the resulting pseudo-2D VS cross-sections have been largely limited to synthetic data. In response, this study utilizes DAS data to examine the effects of using various sub-array lengths by comparing pseudo-2D VS cross-sections derived from active-source waveforms collected at a well-characterized field site. DAS is particularly useful for 2D MASW applications because the sub-array geometry does not need to be determined prior to field data acquisition. We organize the DAS waveforms into multiple sets of overlapping MASW sub-arrays of differing lengths, ranging from 11 m to 47 m, along the same alignment, allowing for direct comparison of the derived pseudo-2D VS results at the site. We show that the length of the individual MASW sub-arrays has a significant effect on the resulting VS cross-sections, including the resolved location of a strong impedance contrasts at our study site, and evaluate the results relative to ground truth from invasive testing. Our results suggest that the choice of sub-array length is important and should be carefully chosen to meet project-specific goals. Furthermore, analysts may consider using multiple sub-array geometries during the data processing stage, as is made possible by DAS, to properly evaluate the uncertainty of 2D MASW results. This study demonstrates the potential of using DAS to collect data for 2D MASW in a manner that is efficient and flexible, and can be easily scaled up for use with very long arrays.

geochemistry & geophysics

What problem does this paper attempt to address?

The problem this paper attempts to address is the impact of subarray length selection on the shear wave velocity (V_S) profile in 2D multichannel analysis of surface waves (2D MASW). Traditional 2D MASW methods typically use fixed subarray geometries, which limits the evaluation of the effects of different subarray lengths. This paper explores the impact of different subarray lengths on 2D MASW results using distributed acoustic sensing (DAS) technology, particularly in terms of the ability to identify and resolve subsurface layer interfaces and anomalies.

Specifically, the researchers used DAS technology to record the propagation of seismic waves and generated different pseudo-2D V_S profiles by varying the subarray length. These profiles were compared with field borehole data to assess the effects of different subarray lengths. The study results indicate that the choice of subarray length has a significant impact on 2D MASW results, and therefore, appropriate subarray lengths should be carefully selected in practical applications to meet the specific objectives of the project. Additionally, the study suggests considering multiple subarray geometries during the data processing stage to better assess the uncertainty of 2D MASW results.