Abstract:Summary Distributed acoustic sensing (DAS) is a relatively new technology for recording the propagation of seismic waves, with promising applications in both engineering and geophysics. DAS's ability to simultaneously collect high spatial resolution waveforms over long arrays suggests that it is well-suited for near-surface imaging applications such as 2D MASW (multichannel analysis of surface waves), which require, at a minimum, long, linear arrays of single-component receivers. The 2D MASW method uses a large number of sensor sub-arrays deployed along a linear alignment to produce 1D shear-wave velocity (VS) profiles beneath each sub-array. The 1D VS profiles are then combined to form a pseudo-2D VS image beneath the entire linear alignment that can be used for the purpose of identifying and characterizing lateral variations in subsurface layering. Traditionally, 2D MASW is conducted using arrays consisting of either 24 or 48 geophones. While additional receivers could easily be incorporated into the testing configuration, it is rare for researchers and practitioners to have access to greater numbers of seismographs and geophones. When a limited number of geophones are available for deployment, there is a need to pre-determine the geophone spacing and sub-array length prior to field data acquisition. Studies examining how the choice of sub-array geometry impacts the resulting pseudo-2D VS cross-sections have been largely limited to synthetic data. In response, this study utilizes DAS data to examine the effects of using various sub-array lengths by comparing pseudo-2D VS cross-sections derived from active-source waveforms collected at a well-characterized field site. DAS is particularly useful for 2D MASW applications because the sub-array geometry does not need to be determined prior to field data acquisition. We organize the DAS waveforms into multiple sets of overlapping MASW sub-arrays of differing lengths, ranging from 11 m to 47 m, along the same alignment, allowing for direct comparison of the derived pseudo-2D VS results at the site. We show that the length of the individual MASW sub-arrays has a significant effect on the resulting VS cross-sections, including the resolved location of a strong impedance contrasts at our study site, and evaluate the results relative to ground truth from invasive testing. Our results suggest that the choice of sub-array length is important and should be carefully chosen to meet project-specific goals. Furthermore, analysts may consider using multiple sub-array geometries during the data processing stage, as is made possible by DAS, to properly evaluate the uncertainty of 2D MASW results. This study demonstrates the potential of using DAS to collect data for 2D MASW in a manner that is efficient and flexible, and can be easily scaled up for use with very long arrays.

Transdimensional surface wave tomography of the near-surface: Application to DAS data

Extracting High-Resolution, Multi-Mode Surface Wave Dispersion Data from Distributed Acoustic Sensing Measurements using the Multichannel Analysis of Surface Waves

Studying Surface Structure in Desert Areas Using Multiple Kinds of Surface Wave Data

Measurement of Surface-Wave Phase-Velocity Dispersion on Mixed Inertial Seismometer – Distributed Acoustic Sensing Seismic Noise Cross-Correlations

Blast-Assisted Subsurface Characterisation Using a Novel Distributed Acoustic Sensing Setup Based on Geometric Phases

Reconstruction of Nearshore Surface Gravity Wave Heights From Distributed Acoustic Sensing Data

Near-surface Characterization Using a Roadside Distributed Acoustic Sensing Array

Multigrid Spatially Constrained Dispersion Curve Inversion for Distributed Acoustic Sensing (DAS)

3D Near-Surface P-wave Velocity Structure Imaging with Distributed Acoustic Sensing and Electric Hammer Source

On the Potential of 3D Transdimensional Surface Wave Tomography for Geothermal Prospecting of the Reykjanes Peninsula

Urban subsurface exploration improved by denoising of virtual shot gathers from Distributed Acoustic Sensing ambient noise

Enhancing Subsurface Seismic Profiling with Distributed Acoustic Sensing and Optimization Algorithms

Feasibility Study of Anisotropic Full-Waveform Inversion with DAS Data in a Vertical Seismic Profile Configuration at the Newell County Facility, Alberta, Canada

DAS for 2D MASW Imaging: A Case Study on the Benefits of Flexible Sub-Array Processing

Surface Wave Tomography to Retrieve Near Surface Velocity Models

Exploiting the Potential of Urban DAS Grids: Ambient-Noise Subsurface Imaging Using Joint Rayleigh and Love Waves

Distributed acoustic sensing for seismic surface wave data acquisition in an intertidal environment

Direct surface wave tomography for three dimensional structure based on surface wave traveltimes: Methodology review and applications

High-Resolution Characterization of Near-Surface Structures by Surface-Wave Inversions: From Dispersion Curve to Full Waveform

2-D Phase Unwrapping in DAS Based on Transport-of-Intensity-Equation: Principle, Algorithm and Field Test

Shallow structure imaging using higher-mode Rayleigh waves based on F-J transform in DAS observation