Effect of nitroethane on explosion parameters of multi-component mixed fuel aerosol

Kai Sun,Qi Zhang
DOI: https://doi.org/10.1016/j.fuel.2022.123897
IF: 7.4
2022-07-01
Fuel
Abstract:Through a series of experiments in a 20 L cylindrical vessel, the explosion characteristics of three mixed fuel (propylene oxide/nitroethane, n-heptane/nitroethane and cyclohexene/nitroethane) aerosols under high-temperature source ignition were analyzed, and the transient concentration and droplet size of the mixed fuel aerosols on the explosion characteristics was measured. The effect of nitroethane on the explosion parameters of the multi-component mixed fuel aerosol was obtained. The results show that with the increase of the mass fraction of nitroethane, the concentrations of liquid-phase in the three mixed fuel aerosols decreases linearly and the concentrations of vapour-phase increases linearly. The vapour-phase explosion can generate a higher pressure than the liquid-phase. Compared with cyclohexene and n-heptane, propylene oxide has better gasification performance and the explosion pressure of propylene oxide/nitroethane is higher under the similar experimental conditions. At the examined range from 0% to 100% for the mass fraction of nitroethane, both the explosion pressure and the maximum rate of pressure rise reach highest also at the mass fraction of nitroethane of 33%. At the mass fraction of nitroethane of 33%, the explosion pressures of the three fuel aerosols, propylene oxide/nitroethane, n-heptane/nitroethane and cyclohexene/nitroethane, are 1.47 MPa, 1.38 MPa and 1.28 MPa, respectively. At the mass fraction of nitroethane of 33%, the maximum rates of pressure rise of the three fuel aerosols are 143.16 kPa·ms−1, 122.7 kPa·ms−1 and 94.3 kPa·ms−1, respectively.
energy & fuels,engineering, chemical
What problem does this paper attempt to address?