Abstract:Thermal rectification devices based on solid-liquid phase change material (PCM) can realize efficient and reversible control of forward and reverse heat flux. In this study, an analytical solution for a shell-and-tube phase change thermal rectifier is derived based on Fourier's law of heat conduction. The validity of the analytical model is confirmed by the numerical model verified by the exact solution of the single-phase Stefan problem. The influence of thermophysical properties, structural parameters, and initial temperature on the dynamic and static thermal rectification effects of the shell-and-tube heterojunction composed of polydimethylsiloxane (PDMS) and hexadecane (C16) is investigated and optimized. Results indicate that the proposed analytical model for the shelland-tube phase change thermal rectifier enables rapid and precise prediction of thermal rectification effects. The presence of solid-liquid phases of C16 under forward and reverse heat transfer modes reduced the thermal resistance difference, resulting in poor initial rectification performance (only about 1.17). The optimized thermal rectification effect is significantly increased to 1.56, which is significantly improved by 33.56 %. Moreover, the dynamic rectification effect of the shell-and-tube thermal rectifier is notably higher than the static rectification effect. The average dynamic thermal rectification ratio within the first 50 s before and after optimization is 2.19 and 7.80, respectively, which is several times higher than the static thermal rectification ratio. This paper further analyzes the impact of initial temperature and finds that an increase in initial temperature can further enhance the dynamic thermal rectification effect. Raising the initial temperature to 5 K above the phase change temperature can increase the improvement of the dynamic rectification effect to 256.36 % in the first 50 s. The significance of this study lies in its potential to advance the understanding and practical application of thermal rectification based on PCM.

Experimental Study of Single-phase Change Material Thermal Diode Based on Calcium Chloride Hexahydrate

Thermal conductivity measurement of phase-change material near melting point based on perturbation method

Dual Phase Change Thermal Diodes with High Rectification for Thermal Management near Room Temperature

Experimental Research of the Heat Storage Performance of a Magnesium Nitrate Hexahydrate-Based Phase Change Material for Building Heating

Ultra-soft Thermal Diodes Enabled by Dual-Alkane-Based Phase Change Composites

Investigation on the Melting Performance of a Phase Change Material Based on a Shell-and-Tube Thermal Energy Storage Unit with a Rectangular Fin Configuration

Preparation and Characterization of Expanded Dickite/decanoic Acid Phase-Change Materials

Supercooling-enabled giant and tunable thermal rectification ratio of a phase change thermal diode

Analysis and Optimization of Dynamic and Static Thermal Rectification in Shell-and-tube Phase Change Thermal Rectifiers

Thermal Diodes Based on Fractal Structures with Tunable Thermal Threshold

Phase-change radiative thermal diode

Experimental study of mechanical-capillary driven phase-change loop for heat dissipation of electronic devices and batteries

Experimental Study on the Effect of Additives for Phase Change Hysteresis Performance

Controllable Thermal Rectification Realized in Binary Phase Change Composites

Thermal characteristics of room temperature inorganic phase change system containing calcium chloride

Experiment and calculation of charge and release characteristics of phase change electronic heat storage system

Vapor–Liquid Transition‐Based Broadband Light Modulation for Self‐Adaptive Thermal Management

Study on Influencing Factors of Phase Transition Hysteresis in the Phase Change Energy Storage

Experimental investigation of thermal performance in a shell-and-tube phase change thermal energy storage unit with an inner square tube

Thermal Management of Conventional Photovoltaic Module Using Phase Change Materials—an Experimental Investigation

Experimental and numerical investigations on the intermittent heat transfer performance of rectangular cavity plate fin phase change material based heat sink