Optimized Low Frequency Temperature Modulation for Improving the Selectivity and Linearity of SnO 2 Gas Sensor

Wen-Jie Zhao,Kai-Lun Ding,Yin-Sheng Chen,Fang-Ying Xie,Dan Xu

DOI: https://doi.org/10.1109/jsen.2020.2993055

IF: 4.3

2020-09-15

IEEE Sensors Journal

Abstract:The disadvantages of poor selectivity, thermal instability and nonlinear output for metal oxide semiconductor (MOS) gas sensors restrict their detection accuracy for flammable and toxic gases. In this paper, a low frequency dynamic temperature modulation detection method using rectangular wave was designed and first proposed herein. The temperature modulation detection mechanism was also provided in detail. The flammable gases CH₄ and CO were detected successfully using this method by self-made indirectly Pt/SnO₂ sensors. The results show that the response time of the Pt/SnO₂ sensors is 9 s and 8 s, and the recovery time is 25 s and 23 s for 100 ppm CH₄ and CO, using the rectangular wave temperature modulation with a working temperature of 335-382 °C and an optimized frequency of 100 mHz. The temperature modulation has more advantages than steady-state constant temperature method in power consumption and working temperature. The temperature-modulated response for CH₄ and CO, are highly linear with the gas concentration without using the log coordinates. The selectivity of the Pt/SnO₂ sensors for 500 ppm CH₄ and CO is enhanced from 2.03 using the traditional steady-state constant temperature detection to 2.56 using the temperature modulation method. Compared with the steady-state constant temperature method, both the selectivity and linearity of the response output for the Pt/SnO₂ sensors are improved by this method, and an effective detection can be realized for a wide gas concentration range of 0–500 ppm CH₄ and CO. It provides a new potential detection pathway for MOS-based gas sensors.

engineering, electrical & electronic,instruments & instrumentation,physics, applied