Abstract:This article presents experimental and computational results on ignition of nonpremixed, counterflowing jets of nitrogen-diluted methane versus heated air within a wide range of pressures, fuel concentrations, and flow strain rates. The system was brought to ignition by increasing gradually the temperature of the air stream. Each steady-state situation just prior to ignition was experimentally characterized by measuring detailed centerline axial flow velocity and temperature distributions, for ambient pressures between 0.5-8.0 atm, fuel concentrations in the range of 6%-100% methane in nitrogen, and pressure-weighted strain rates between 100-700 s(-1). In addition, each situation was modeled numerically, using detailed transport properties and full chemical kinetics based on the GRI (Gas Research Institute) Mech v1.2 mechanism. As in our previous work with hydrogen/air ignition, we have identified computationally the existence of a localized ignition kernel of maximum reactivity and heat release. In contrast to the hydrogen case, however, we have shown that heat release and the thermal feedback are indispensable at ignition in the methane/air system. The ignition temperature, defined as the boundary temperature of the air jet just prior to ignition, was found to increase with increasing flow strain rate at all pressures. This has been shown numerically to be an effect of heat and radical loss out of the ignition kernel by convective-diffusive transport. The ignition temperature decreased abruptly with increasing fuel concentration, for dilute conditions. For CH4 concentrations in excess of 20%-30%, however, the ignition temperature became insensitive to further increase in the fuel concentration. Ignition temperatures at constant pressure-weighted strain rates decreased monotonically with increasing system pressure, similar to the homogeneous explosion limits. Over this range of pressures the numerical simulation indicated that the dominant chemical pathways at ignition do not change significantly. Flux, sensitivity, and the Computational Singular Perturbation (CSP) method were used to identify the ignition chemistry and provide several simplified kinetic mechanisms. The results obtained using a skeletal mechanism M4, with 22 species and 64 irreversible reactions, were found to agree closely with those obtained using the full chemistry. The experimental data were compared with computations using several kinetic mechanisms. Copyright (C) 1997 by The Combustion Institute.

The Discussion of Ignition Criterion About the Mechanical Spark Ignition of Near-Limit Methane-Air Mixtures

Numerical Investigation of Methane Number and Wobbe Index Effects in Lean-Burn Natural Gas Spark-Ignition Combustion

A Numerical Study into the Importance of Equivalence Ratio Measurement Accuracy for Spark Ignition Engines

Numerical Investigation of the Fuel/Air Ratio Sensor Sensitivity in a Port-Fuel-Injected Spark-Ignition Engine Equipped with Three-Way Catalysts

Numerical Investigation of the Effect of Ammonia Addition on the Performance of a Stoichiometric Operated Natural Gas Spark Ignition Engine

The Effect of Methane Addition on the Low-Temperature Oxidation Preparation and the Thermal Ignition Preparation of Dimethyl Ether under Representative Engine In-Cylinder Thermal Conditions

A shock-tube experimental and kinetic simulation study on the autoignition of methane at ultra-lean and lean conditions

Hot Surface Ignition of Ethylene-Air mixtures : Selection of Reaction Models for CFD Simulations

Optical Study on the Effects of Methane Equivalence Ratio and Diesel Injection Mass on Diesel-Ignited Methane Combustion Process

Investigating Auto-Ignition Characteristics and Kinetic Modeling of NH3/CH4 Mixtures Using an RCM

Simulation and Research of Methane Premixed Combustion Characteristics Based on Constant Volume Combustion Chamber with Different Ignition Modes

Ignition of counterflowing methane versus heated air under reduced and elevated pressures

Experimental study of microwave assisted spark ignition on expanding C2H2-Air spherical flames

Experimental Study on Premixed Combustion Characteristics of Methane-Air under Dual Spark Plug Ignition Strategy in a Closed Spherical Chamber

Combustion characteristics of ignition processes for lean premixed swirling combustor under visual conditions

Numerical comparative study on knocking combustion of high compression ratio spark ignition engine fueled with methanol, ethanol and methane based on detailed chemical kinetics

Methane/Air Auto-Ignition Based on Global Quasi-Linearization (GQL) and Directed Relation Graph (DRG): Implementation and Comparison

Ignition Characteristics of Dual-Fuel Methane-N-hexane-oxygen-diluent Mixtures in a Rapid Compression Machine and a Shock Tube

Chemical Insights into the Two-Stage Ignition Behavior of NH3/H2 Mixtures in an RCM

Analysis of the Ignition Behavior Based on Similarity Factor Method

Investigation of Methanol Ignition Phenomena Using a Rapid Compression Machine