Abstract:Brake-by-wire systems are one of the key components in intelligent/unmanned vehicles that have attracted worldwide attention. Testing and evaluation of brake-by-wire systems are a significant step during the development of the technology of vehicular braking and further the advancement of intelligent/unmanned vehicles. Using the test bench to simulate different road adhesion coefficients (i.e. road surfaces) and to complete the testing and evaluation of the vehicle braking systems is of great significance and importance. A test bench for simulation of vehicular braking of 1/4 vehicle is presented and investigated in this article. It is composed of a motor, two rollers, a 1/4 vehicle suspension system, a magnetic powder clutch, a flywheel, sensors, a signal acquisition and processing system, and a controller. The wheel and vehicle speeds are simulated by the rollers and flywheel speeds, respectively. The translational kinetic energy of 1/4 vehicle is simulated by the rotational kinetic energy of the flywheel. The signal acquisition and processing system is used to acquire and process the experimental signals, such as rotational speeds and torques during tests. The magnetic powder clutch with adjusted applied currents in the test bench is used to real-timely simulate roads with different adhesion coefficients. Based on the working principle of the test bench and the fundamentals of vehicle dynamics, the prototype of the test bench is established and the simulation approach of the translational kinetic energy of 1/4 vehicle is investigated. The mathematical model of the real-time simulation about roads with different adhesion coefficients based on the magnetic powder clutch with real-time controllable transmitted torque is established. With the built 1/4 vehicle braking systems based on the test bench and road, and the corresponding established models, the comparison and analysis of the simulation results of various road surfaces are conducted. Experiments are sequentially implemented to verify the feasibility and effectiveness of the test bench.

An Innovative HiL Test Environment with a Fully Integrated Brake System and Automated Brake Performance Evaluation

Development of integrated hardware-in-the-loop (hil) test bench anti-lock brake system (abs) instrument

An Automatic Testing System for Vehicle's Drive Axis Performance Test

The Development of Dynamic Test Bench for EV Hybrid Brake System

Development of Air-Abs-Hil-Simulation Test Bench

The rapid development of vehicle electronic control system by hardware-in-the-loop simulation

A Novel Regenerative Electrohydraulic Brake System: Development and Hardware-in-Loop Tests

A Novel Integrated Simulation and Testing Platform for Self-Driving Cars with Hardware in the Loop.

Design, modeling, and verification of a test bench for braking simulation of 1/4 vehicle

Co-Simulation On Performance Evaluation Of A New Electronic Control Hydraulic Braking System

Hardware-In-the-Loop for Connected Automated Vehicles Testing in Real Traffic

Design and Development of a Brake Test Bench for Formula SAE Race Cars

Engine-in-the-Loop in practical application: A sensitivity study toward the influence of test bench parameters

Testing System for the Braking Performance of an Automobile Based on LabVIEW

Hardware-in-the-loop Test Bench for Electromechanical Brake System

A Virtual Testing Framework for Real-Time Validation of Automotive Software Systems Based on Hardware in the Loop and Fault Injection

Driving Robot for Reproducible Testing: A Novel Combination of Pedal and Steering Robot on a Steerable Vehicle Test Bench

The Development of A Real-Time Hardware-in-the-Loop Test Bench for Hybrid Electric Vehicles Based on Multi-Thread Technology

Study on Electro-Hydraulic Parallel Brake System using HILS

Development of a driver information and warning system with vehicle hardware-in-the-loop simulations

An Explicit Nonlinear Model Predictive ABS Controller for Electro-Hydraulic Braking Systems