Abstract:Summary form only given. Non-equilibrium low-temperature plasmas sustained at atmospheric pressure, which are very promising for a range of advanced applications from health care and medicine to materials science and nanotechnology 1-8 . Upon reduction to micrometer dimensions, plasmas not only show unique physical properties (e.g., extreme thermal non-equilibrium), but also enable an unprecedented access to a largely unexplored region of the plasma phase parameter space. Present-day micro-plasmas are confined to micro-cavities of the typical dimensions in the ten-to-hundreds micrometers and the aspect (length-to-depth/width) ratios in the 1:1 to 20:1 ranges. The electron/ion density of such micro-plasmas is typically ~10 11 -10 15 cm -3 .As the discharge size is reduced, it becomes more difficult to generate the plasma and maintain its charge neutrality (ne = ni), where ne and ni are the electron and ion densities, respectively. In this paper9, an atmospheric pressure nonequilibrium Ar micro-plasma generated inside a micro-tube with plasma radius of 3 μm and length of 2.7 cm is reported. The electron density of the plasma plume estimated from the broadening of the Ar emission line reaches as high as 3x10 16 cm -3 . The electron temperature obtained from CR model is 1.5 ev while the gas temperature of the plasma estimated from the N 2 rotational spectrum is close to room temperature. The sheath thickness of the plasma could be close to the radius of the plasma. The ignition voltages of the plasma increase one order when the radius of the dielectric tube is decreased from 1 mm to 3 μm.

A stable atmospheric-pressure plasma for extreme-temperature synthesis

Recent Progresses in Material Fabrication and Modification by Cold Plasma Technique

Continuous batch synthesis with atmospheric-pressure microwave plasmas

Generation of Large-volume Plasma Under Low Air-pressure and Study of Its Electrical Characteristics

Designing Atmospheric-Pressure Plasma Sources for Surface Engineering of Nanomaterials

State-of-the-art Development of Research and Applications of Chemical Conversion Processes at Ultra-High Temperature in Thermal Plasma Reactors

Development and Optimization of Step-A Linear Plasma Device for Plasma-Material Interaction Studies

Plasma-surface Interaction Experimental Device: PSIEC and Its First Plasma Exposure Experiments on Bulk Tungsten and Coatings

Plasma-target surface interaction during non-equilibrium plasma irradiation at atmospheric pressure: Generation of dusty plasma

An Atmospheric-Pressure, Room-Temperature, Cold Micro Plasma

Cold Microplasma Plume Produced by a Compact and Flexible Generator at Atmospheric Pressure

Micro/Nano Composited Tungsten Material and Its High Thermal Loading Behavior

Ultrafast high-temperature heating in air

Explosive Consolidation and Its Application on Preparing of Ultra-Fine Grained Tungsten Plasma Facing Material

A Cold Plasma Jet Device with Multiple Plasma Plumes Merged

Development of an Atmospheric-Pressure Homogeneous and Cold Ar/O-2 Plasma Source Operating in Glow Discharge

The plasma pencil: a novel cold plasma source for low temperature applications

Design of a Flexible Microwave-Induced Room-Temperature Atmospheric-Pressure Microplasma Source

Grand challenges in low temperature plasmas

Fundamental Study and Process Intensification in Plasma Multiphase Reactors

Low-temperature growth processes with helicon radio-frequency plasmas. TiO2 films and Pt/C nano-clusters