Abstract:Nuclear power overhaul can benefit from a fiber-optic laser-induced breakdown spectroscopy (FO-LIBS) setup for in situ composition measurements. Regarding FO-LIBS, the pulsed energy of the fiber-delivery laser is limited, and the spot profile received by the sample surface is distorted from a Gaussian to a flat-top distribution. Therefore, the induced plasma in FO-LIBS is characterized by weakened emission, shortened lifetime, and insufficient sampling of minor components compared with that of conventional LIBS. This could not meet the quantitative demands of the minor component with a concentration of 0.01 wt% or lower in structural steel. In this study, by modifying the mechanical structure of the front-end sensor, a space constraint condition can be created for plasma emission enhancement. By combining the optical diagnostics of fast photograph and shadowgraph, shockwave propagation and plasma expansion can be visualized synchronously. The reflected shockwave decelerates in the process of propagating towards the plasma, accompanied by morphological changes from the oblate cylinder to the hemisphere. It can be demonstrated that the plasma is constricted by the reflected shockwave associated with a significant increase in the plasma temperature and electron number density. The plate spacing determines the time delay of spectral enhancement and also determines the enhancement factor corresponding to the velocity attenuation of shockwave propagation over a long distance. The enhancement factor is found to be inversely proportional to the quadratic square of the propagation velocity of shockwave just after reflection, and shows an upward trend with increasing upper-level energy of atomic transitions. A maximum enhancement factor of ~3.52 is realized with a time delay of 4 μs at a plate spacing of 3 mm, and trace components Mo, V, and Cu are newly recognized, which cannot be observed in conventional FO-LIBS. Meanwhile, the calibration of trace Cr and Mn suggests that the quantitative results using the sensor coupled with spatial confinement are comparable, and the limits of detection are reduced to 31 ppm and 475 ppm, respectively.

Vacuum degree detection performance improvement of vacuum switches based on NELIBS

A Pilot Study on the Vacuum Degree Online Detection of Vacuum Interrupter Using Laser-Induced Breakdown Spectroscopy

Preliminary study on vacuum degree online detection of vacuum circuit breaker based on laser induced breakdown spectroscopy(LIBS)

Experimental Study of Vacuum Degree Online Detection of Vacuum Interrupter Based on Laser Induced Breakdown Spectroscopy

Performance investigation of pre-ablation and reheating orthogonal double-pulse nanoparticle enhanced laser-induced breakdown spectroscopy

A comparative study of nanoparticle-enhanced laser-induced breakdown spectroscopy

Study on the Laser-Induced Plasma Properties of Vacuum Interrupter Shield under Different Pressure

Enhancement of Laser-Induced Breakdown Spectroscopy (LIBS) Detection Limit Using a Low-Pressure and Short-Pulse Laser-Induced Plasma Process

Vacuum Detection Equipment of Vacuum Switch Based on Laser-Induced Plasma Imaging

Performance improvement of underwater LIBS qualitative and quantitative analysis by irradiating with long nanosecond pulses.

Improvement of the Spatial Resolution of the Spatial Mapping of Metallic Coatings by Using Picosecond LIBS

Laser-Induced Breakdown Spectroscopy System for Elements Analysis in High-Temperature and Vacuum Environment

Emission Enhancement of Laser-Induced Breakdown Spectroscopy for Aqueous Sample Analysis Based on Au Nanoparticles and Solid-Phase Substrate.

Novel Signal Enhancement Strategy for Laser-Induced Breakdown Spectroscopy via Miniaturized Atmospheric Pressure Glow Discharge

Significant enhancment of the accuracy of impurity determination in vacuums using classification one-point laser-induced breakdown spectroscopy

High Precision Measurement of Electric Field at the Nanoscale in Optomechanical Systems

Optimization of nanoparticle-enhanced laser-induced breakdown spectroscopy for the hyperspectral chemical mapping of solid samples

Study on the Impact of Air Pressure on the Laser-Induced Breakdown Spectroscopy of Intumescent Fireproof Coatings

Sensitivity improvement in the measurement of minor components by spatial confinement in fiber-optic laser-induced breakdown spectroscopy

Research on Improving the Accuracy of Laser-Induced Breakdown Spectroscopy Analysis by Considering Plasma Attenuation Rate Characteristics

Morphological tracking and tuning of silica NPs for stable levitation in vacuum optomechanical systems