Abstract:We propose a new technique to fabricate a highly specialized optical element, a hybrid planar Grating/Fresnel lens (G-Fresnel), which is particularly useful to improve or enable more-affordable miniature/portable spectrometers. Both the Fresnel and the grating surface are fabricated simultaneously by sandwiching soft PDMS between a hard grating and a pre-replicated negative Fresnel surface. Several adhesion reduction techniques are also investigated that help improve both fabrication and cost efficiency (by reducing the solidification time) as well as the lifetime of the mold. Alignment errors are systematically analyzed, and their effects on the G-Fresnel lens evaluated. A compact fabrication platform was built, which is smaller than a volume of 160 x 140 x 106 mm(3) to fit into a conventional vacuum drying oven, for the fabrication of a G-Fresnel lens with a diameter of 25.4 mm, an equivalent focal length of 25 mm, and a blazed grating pattern with 600 lines/mm spacing. The solidification time was reduced to 2 hours thanks to the improved adhesion reduction technique that permits a PDMS drying-temperature as high as 65 degrees C. The fabricated G-Fresnel lens was evaluated with regard to both geometrical fabrication precision and optical performance. The measured results, using a step gauge and atomic force microscopy, confirm that this replication technique produces high-quality replicates of the master surface-profile. Furthermore, a prototype spectrometer that uses a G-Fresnel lens was built and evaluated. The spectrometer fits within a volume of about 100 mm x 50 mm x 30 mm, and it operates across a wide wavelength spectrum (450 nm to 650 nm). Both the calculation based on the optical software ZEMAX and the experimental measurements are consistent and confirm that the spectrometer with the G-Fresnel lens can provide a spectral resolution of better than 1.2 nm. (C) 2018 Optical Society of America under the terms of the OSA Open Access Publishing Agreement

Development of ground-testable phase fresnel lenses in silicon

Carbon-based Fresnel optics for hard x-ray astronomy

Optimization of Grayscale Lithography for the Fabrication of Flat Diffractive Infrared Lenses on Silicon Wafers

Design and imaging performance of achromatic diffractive/refractive X-ray and Gamma-ray Fresnel lenses

Monolithic Kilopixel Silicon Microlens Arrays for Future Far-Infrared Observatories

Femtosecond Laser Ablation for Manufacturing of X-ray Lenses and Phase Corrector Plates

Economic fabrication of a novel hybrid planar Grating/Fresnel lens for miniature spectrometers

Fresnel Interferometric Imager: ground-based prototype

Formation Flying for a Fresnel Lens Observatory Mission

Freeform Liquid–Crystal Polarization Imaging Optics: A Practical Approach from Design to Fabrication

Fabrication Of Grating-Fresnel Lens By Using Pdms Based Soft Lithography

Phase-Type Fresnel Zone Plate with Multi-Wavelength Imaging Embedded in Fluoroaluminate Glass Fabricated via Ultraviolet Femtosecond Laser Lithography

Ion beam lithography for Fresnel zone plates in X-ray microscopy

Analysis, Design and Fabrication of centimeter-wave Dielectric Fresnel Zone Plate Lens and reflector

Efficiency and coherence preservation studies of Be refractive lenses for XFELO application

Structure of poly(propyl ether imine) (PETIM) dendrimer from fully atomistic molecular Dynamics Simulation and by Small Angle X-ray scattering

Fraxicon for Optical Applications with Aperture ∼1 mm: Characterisation Study

Flat silicon gradient index lens with deep reactive-ion-etched 3-layer anti-reflection structure for millimeter and submillimeter wavelengths

Demonstration of 12 nm Resolution Fresnel Zone Plate Lens based Soft X-ray Microscopy

Demonstration of a PDMS based hybrid grating and Fresnel lens (G-Fresnel) device

Improvements on Fresnel arrays for high contrast imaging