Abstract:Abstract Fiber-optic cables cemented outside of the casing of an unconventional well measure cross-well strain changes during fracturing of neighboring wells with low-frequency distributed acoustic sensing (LF-DAS). As a hydraulic fracture intersects an observation well instrumented with fiber-optic cables, fracture fluid injected at ambient temperatures can cool a section of the sensing fiber. Often, LF-DAS and distributed temperature sensing (DTS) cables are run in tandem, enabling the detection of such cooling events. The increasing use of LF-DAS for characterizing unconventional hydraulic fracture completions demands an investigation of the effects of temperature on the measured strain response by LF-DAS. Researchers have demonstrated that LF-DAS can be used to extract the temporal derivative of temperature for use as a differential-temperature-gradient sensor. However, differential-temperature-gradient sensing is predicated on the ability to filter strain components out of the optical signal. In this work, beginning with an equation for optical phase shift of LF-DAS signals, a model relating strain, temperature, and optical phase shift is explicitly developed. The formula provides insights into the relative strength of strain and temperature effects on the phase shift. The uncertainty in the strain-rate measurements due to thermal effects is estimated. The relationship can also be used to quantify uncertainties in differential-temperature-gradient sensors due to strain perturbations. Additionally, a workflow is presented to simulate the LF-DAS response accounting for both strain and temperature effects. Hydraulic fracture geometries are generated with a 3D fracture simulator for a multi-stage unconventional completion. The fracture width distributions are imported by a displacement discontinuity method program to compute the strain-rates along an observation well. An analytic model is used to approximate the temperature in the fracture. Using the derived formulae for optical phase shift, the model outputs are then used to compute the LF-DAS response at a fiber-optic cable, enabling the generation of waterfall plots including both strain and thermal effects. The model results suggest that before, during, and immediately following a fracture intersecting a well instrumented with fiber, the strain on the fiber drives the LF-DAS signal. However, at later times, as completion fluid cools the observation well, the temperature component of the LF-DAS signal can equal or exceed the strain component. The modeled results are compared to a published field case in an attempt to enhance interpretation of LF-DAS waterfall plots. Finally, we propose a sensing configuration in order to identify the events when "wet fractures" (fractures with fluids) intersect the observation well.

Could fiber strains affect DAS amplitude response?

Thermal Effects on Far-Field Distributed Acoustic Strain-Rate Sensors

Calibration of the strain amplitude recorded with DAS using a strainmeter array

Microanchored borehole fiber optics allows strain profiling of the shallow subsurface

Experimental Investigation of Low-Frequency Distributed Acoustic Strain-Rate Responses to Propagating Fractures

Evaluating Dark Fiber Distributed Acoustic and Strain Sensing for Shallow Ground Movement Monitoring: A Field Trial

Quantifying Progressive Failure of Micro-Anchored Fiber Optic Cable–Sand Interface via High-Resolution Distributed Strain Sensing

Traffic Vibration Signal Analysis of DAS Fiber Optic Cables with Different Coupling Based on an Improved Wavelet Thresholding Method

Strain transfer effect on measurements with distributed fiber optic sensors

Strain Transfer Mechanisms and Mechanical Properties of Optical Fiber Cables

Distributed Acoustic Sensing With Sensitivity-Enhanced Optical Cable

Strain Transfer Mechanism in Surface-Bonded Distributed Fiber Optic Sensors under Different Strain Fields

Experimental Research on Strain Transfer Behavior of Fiber-Optic Cable Embedded in Soil Using Distributed Strain Sensing

The stability of optical fiber as strain sensor under invariable stress

Toward Distributed Fiber‐Optic Sensing of Subsurface Deformation: A Theoretical Quantification of Ground‐Borehole‐Cable Interaction

The Impact of Liquids and Saturated Salt Solutions on Polymer-Coated Fiber Optic Sensors for Distributed Strain and Temperature Measurement

Linking distributed and integrated fiber-optic sensing

Spiral Deployment of Optical Fiber Sensors for Distributed Strain Measurement in Seven-Wire Twisted Steel Cables, Post-Tensioned against Precast Concrete Bars

Strain field reconstruction from helical-winding fiber distributed acoustic sensing and its application in anisotropic elastic reverse time migration

Assessing the Impact of Borehole Coupling Materials on Shallow Downhole Fiber-Optic Distributed Acoustic Sensing (FO-DAS) Using Laboratory Simulations

Fiber-optic distributed acoustic sensor based on a chirped pulse and a non-matched filter