Abstract:Zinc oxide (ZnO) nanorods (NRs) have been investigated as a function of different growth temperature using modified chemical bath deposition (M-CBD) method. In this study, air bubbles were utilized inside the growth solution as an original modified process. The synthesis of ZnO NRs was carried out through two steps. The first step was deposition of the ZnO seed layer on the glass substrate, while the second step was growing the ZnO NRs on the seeded substrate. The impacts of the growth temperature on the morphology and crystal structure of the ZnO samples were investigated using field emission scanning electron microscopy and x-ray diffraction. UV–Vis spectroscopy was also utilized to characterize the optical properties of the ZnO NRs. The results showed that the growth of the ZnO samples is a NRs-like shape. The ZnO samples possess the hexagonal wurtzite structure with high crystal quality, and no other phases from the impurity were observed. Additionally,the ZnO NRs were found to be well oriented along te (002) planes with diameters ranging from 71 nm to 328 nm and length from 294 nm to 2475 nm, while the aspect ratio was up to 25 with different growth temperatures. However, the UV–Vis spectrum showed that the optical transmittance of the ZnO NRs dropped from ~ 66% to ~ 3.3%, and the absorption band edge had been shifted to a lower-energy region as the growth temperature increased from 65°C to 95°C. This is possibly due to the scattering increase and absorption light from voids, grain size, and thickness of the ZnO NRs. Therefore, it has been demonstrated that the ZnO NRs grown by the M-CBD method at a growth temperature of 95°C gives the most favorable result, since the NRs possess the optimum, homogenous, and uniform distribution with a higher aspect ratio, crystal quality, crystal size, and band gap energy.

The Effect of Cooling Rate During the Hydrothermal Growth on the Tip Geometry of ZnO Nanorods

Effect of UV irradiation on the properties of ZnO nanorod arrays prepared by hydrothermal method

Morphology Investigation of Hydrothermally Prepared ZnO Micro-Crystals Influenced by Cu2+ Ions

Sequential Occurrence of ZnO Nanopaticles, Nanorods, and Nanotips During Hydrothermal Process in a Dilute Aqueous Solution

Effects of Electrodeposition Electrolyte Concentration on Microstructure, Optical Properties and Wettability of ZnO Nanorods

Alignment-controlled Hydrothermal Growth of Well-Aligned ZnO Nanorod Arrays

Hydrothermal Synthesis of Well-Aligned ZnO Nanorod Arrays on Silicon

Influence of hydrothermal time on structural properties of ZnO nanorods grown on spin-coated ZnO seeding layer

A Simple and Novel Low-Temperature Hydrothermal Synthesis of ZnO Nanorods

The effect of pre-annealing of sputtered ZnO seed layers on growth of ZnO nanorods through a hydrothermal method

Single-crystal ZnO Nanorods Fabricated with Different End Morphologies

Growth of Variable Aspect Ratio ZnO Nanorods by Hydrothermal Technique

An Approach to Control the Tip Shapes and Properties of ZnO Nanorods

MP-16 the Effect of Cooling Process on Copper Oxide Nanowires Generated by Stress-Induced Method

Facile and Controllable Growth of ZnO 1D Nanostructure Arrays on Zn Substrate by Hydrothermal Process

Growth of flower-like ZnO on ZnO nanorod arrays created on zinc substrate through low-temperature hydrothermal synthesis

Effect of lattice strain on structural and optical properties of ZnO nanorods grown by hydrothermal method

A facile method for the synthesis of tapered ZnO:Cu nanorod arrays and its secondary growth

Effect of Growth Temperature on Morphological, Structural, and Optical Properties of ZnO Nanorods Using Modified Chemical Bath Deposition Method

Structure Transformation of Hydrothermally Treated ZnO Nanorod Array

Effect of Growth Time and Annealing on the Structural Defect Concentration of Hydrothermally Grown Zno Nanowires