Abstract:In the context of the Laser Interferometer Space Antenna (LISA), the laser subsystems exhibit frequency fluctuations that introduce significant levels of noise into the measurements, surpassing the gravitational wave signal by several orders of magnitude. Mitigation is achieved via time-shifting individual measurements in a data processing step known as time-delay interferometry (TDI). The suppression performance of TDI relies on accurate knowledge and consideration of the delays experienced by the interfering lasers. While considerable efforts have been dedicated to the accurate determination of inter-spacecraft ranging delays, the sources for onboard delays have been either neglected or assumed to be known. Contrary to these assumptions, analog delays of the phasemeter front end and the laser modulator are not only large but also prone to change with temperature and heterodyne frequency. This motivates our proposal for a novel method enabling a calibration of these delays on-ground and in-space, based on minimal functional additions to the receiver architecture. Specifically, we establish a set of calibration measurements and elucidate how these measurements are utilized in data processing, leading to the mitigation of the delays in the TDI Michelson variables. Following a performance analysis of the calibration measurements, proposed calibration scheme is assessed through numerical simulations. We find that in the absence of the calibration scheme, the assumed drifts of the analog delays increase residual laser noise at high frequencies of the LISA measurement band. A single, on-ground calibration of the analog delays leads to an improvement by roughly one order of magnitude, while re-calibration in space may improve performance by yet another order of magnitude. Towards lower frequencies, ranging error is always found to be the limiting factor for which countermeasures are discussed.

Improving LIGO calibration accuracy by using time-dependent filters to compensate for temporal variations

Precise calibration of LIGO test mass actuators using photon radiation pressure

Calibration of the LIGO displacement actuators via laser frequency modulation

Initial Results from the LIGO Newtonian Calibrator

Fiducial displacements with improved accuracy for the global network of gravitational wave detectors

Suppression of thermal transients in advanced LIGO interferometers using CO2 laser preheating

Toward Calibration of the Global Network of Gravitational Wave Detectors with Sub-Percent Absolute and Relative Accuracy

Rapid acceleration of electrons in the magnetosphere by fast-mode MHD waves

Adaptive thermal compensation of test masses in advanced LIGO

The Advanced Virgo Photon Calibrators

Online decoupling of the time-varying longitudinal feedback loops for improved performance in Advanced Virgo Plus

Calibrating VLBI Polarization Data Using GPCAL. II. Time-Dependent Calibration

Impact of calibration uncertainties on Hubble constant measurements from gravitational-wave sources

Calibrating VLBI Polarization Data Using GPCAL. I. Frequency-Dependent Calibration

Preventing Transient Parametric Instabilities in High Power Gravitational Wave Detectors Using Thermal Transient Compensation

Front Matter: Volume 9950

Advanced LIGO detector performance in the fourth observing run

Residual Amplitude Modulation in Interferometric Gravitational Wave Detectors

Compensation of front-end and modulation delays in phase and ranging measurements for time-delay interferometry

Achieving resonance in the Advanced LIGO gravitational-wave interferometer

Modeling Ambiguity in a Multi-Agent System