Abstract:The characterization of the geological and geotechnical properties of marine sediments is crucial for the exploration of subsea oil and gas resources. In this study, the engineering properties of deep-water soils recov-ered from the South China Sea (SCS) were in detail characterized via a series of laboratory tests to explore their physical, mechanical, mineralogical and microstructural behaviors. The results show that the index properties of deep-water soils are characterized by high natural water content, high void ratio, high Atterberg limits, but low density. The sensitivity of these soils is higher than 10, indicating their strong natural structure, which signifi-cantly controls the shear behavior and failure model. The intact samples show strain-softening to strain -hardening behavior with an increase in the confining pressure, while reconsolidated samples consistently show strain-hardening phenomenon under any level of confining pressure. The cyclic T-bar penetration tests show a dramatic strength degradation behavior of the intact samples. The compression curves of the intact samples always lie above the remoulded ones, and there is an obvious yielding phenomenon for the intact samples. The deep-water soils exhibit high thixotropy, as proposed by a criterion to evaluate the thixotropic capacity of soils. The mineralogy and microstructure analysis indicate that biogenic silica and an open floccu-lated structure might be the underlying reasons for the unique physical and mechanical properties of deep-water soils. The findings through this study provide essential parameters for related engineering applications and a deeper insight into understanding the unique properties of deep-water soils.

Centrifuge experiment on the penetration test for evaluating undrained strength of deep-sea surface soils

Model Tests on Penetration and Pullout of Suction Caissons in Silt

Free Fall Penetration Test the Undrained Shear Strength of Submarine Sediments

Undrained Shear Strength Measurement For Deep-Sea Surficial Sediments In The West Of South China Sea Using Miniature Full-Flow Penetrometer

Experimental Study on the Undrained Shear Strength of Deep-Sea Soft Soil Using Improved T-bar Penetrometer

Evaluation of Undrained Shear Strength of Surficial Marine Clays Using Ball Penetration-Based CFD Modelling

Assessment of Seabed Trench Formation Based on Marine Sediment Properties and Chain-Bar Penetration Tests

Identification of the Sediment-Water Interface During Field Full-Flow Penetration Tests

Design and Application of a Deep-Sea Engineering Geology In Situ Test System

Assessing the Strength of Deep-Sea Surface Ultrasoft Sediments with T-bar Penetration: A Machine Learning Approach

Improved Predictive Model for the Strength of Fluidized Seabed Sediments with Rate Effect Characteristics by Full-Scale Spherical Penetrometer Tests

First In-situ Full Deep Sea Sediment Strength Testing Device: MEGE

A New Full-Flow Penetrometer for Strength Test of Submarine Mud Flow

A Combination Method for Testing the Mechanical Properties of Ultra-Soft Fine-Grained Soils

Model Tests on Installation Techniques of Suction Caissons in A Soft Clay Seabed

Characterization of Engineering Properties of Deep-Water Soils in the South China Sea

Investigation of Penetration Process of Three Full-flow Penetrometers in Marine Soft Clay

A New Empirical Model for the Undrained Shear Strength of Undisturbed Marine Fine-Grained Soil Based on Piezocone Penetration Tests

Estimation of Undrained Shear Strength in Rate-Dependent and Strain-Softening Surficial Marine Clay Using Ball Penetrometer

Research on in-situ shearing strength and penetration resistance testing of the soft seabed sediments in the eastern part of the Pacific Ocean

Development and Application of a 3,000-M Seabed Cone Penetration Test and Sampling System Based on a Hydraulic Drive