Abstract:Mechanical and thermal damage due to cutting force and temperature rise during bone drilling plays a significant role in implant failure during osteosynthesis. High cutting force results in hole inaccuracy and weakens the stability between bone and implant. In comparison, temperature above 47 °C during drilling of bone results in the permanent death of regenerative bony cells consequences of thermal osteonecrosis. Microcracks at the drill site result in bone delamination and affect the holding strength at the bone-screw interface, resulting in implant failure. Accumulation of bone chips produced during drilling may cause chip clogging. The cutting force, microcracks, bone chip accumulation, and temperature rise are significant reasons for implant instability and revision surgery. Therefore, the present work uses the rotary ultrasonic bone drilling (RUBD) technique of the pig femur bone to monitor cutting force, temperature, microcracks and bone debris generated during the drilling. The results were also compared with conventional bone drilling (CBD). The twisted surgical drill bit was used during CBD and the diamond-impregnated tool was used during RUBD with the same diameters of 3.5 mm. The histopathological analysis was conducted at the drilled site to observe the tissue damage and the effect of heat generation on bone morphology. The output parameters were correlated, and the influence of cutting force on temperature rise, microcracks, and chip morphology was observed. This study showed that the increase in cutting force from 35.63 to 57.66 N in RUBD, and 54.83 to 78.7 N in CBD, resulted in a decrease in temperature rise by 51.5 and 32.7%, respectively. In contrast, the intensity of microcracks and chips size increased with the increase in cutting force for both RUBD and CBD techniques. Moreover, the RUBD technique reduces cutting force, temperature rise, microcracks and bone chip morphology as compared to CBD.

Soft material drilling: A thermo-mechanical analysis of polyurethane foam for biomimetic bone scaffolds and optimization of process parameters using Taguchi method

Parametric Investigation on Different Bone Densities to avoid Thermal Necrosis during Bone Drilling Process

A New Strategy of Carbon Fiber Reinforced Plastic Drilling Evaluation Using Thermal Measurement

Analytical and experimental study of effective parameters on process temperature during cortical bone drilling

Prediction and Optimization of Temperature in Bone Drilling Based on Response Surface Methodology

In-situ temperature monitoring during rotary ultrasonic-assisted drilling of fiber-reinforced composites

On the importance of precision in cortical bone drilling: Integrating experimental validation and computational modeling

Cutting force, Vibration, and Temperature in Drilling on a Thermoplastic Material of PEEK

An in vitro study of thermal necrosis in ultrasonic-assisted drilling of bone

Influence of cutting force on temperature, microcracks and chip morphology during rotary ultrasonic bone drilling: An in-vitro study

A Review of Surgical Bone Drilling and Drill Bit Heat Generation for Implantation

Analysis of clinically relevant mechanical and thermal characteristics of titanium foam spinal implants during drilling

Ultrasonic-assisted drilling of cortical and cancellous bone in a comparative point of view

Analysis of machining process and thermal conditions during vibration-assisted cortical bone drilling based on generated bone chip morphologies

Experimental evaluation and optimization of parameters affecting delamination, geometrical tolerance and surface roughness in ultrasonic drilling of 3D-Printed PLA thermoplastic

A novel self-centring drill bit design for low-trauma bone drilling

An in vitro study of bone drilling: infrared thermography and evaluation of thermal changes of bone and drill bit

Drilling force and temperature of bone under dry and physiological drilling conditions

Optimizing process parameters of fused deposition molding for 3D printing customized control of polyetheretherketone scaffolds

Optimizing the Drilling process parameters of AZ91 based hybrid composites using TOPSIS and Grey Relational Analysis

A Study of the Impact of Multiple drilling parameters on Surface Roughness, Tool wear and Material Removal Rate while Drilling Al6063 applying Taguchi Technique