Abstract:Based on the clinical requirements of temperature control in dental implant surgery, this study aims to establish a theoretical model of the temperature distribution within the bone surrounding the drill hole during the drilling process, and verify it by data of a robotic drilling experiment. A preliminary theoretical model of temperature field during the drilling process, including half-hole and full-hole drilling, is proposed based on the heat transfer theory. To determine the main parameters of the half-hole model, half-hole drilling robotic drilling experiments were conducted on in vitro samples. A thermal imager captured the temperature on the bone section, the parameters were substituted into the model to obtain the revised half-hole model, and then the revised full-hole drilling theoretical model was obtained through establishing the relationship between the half-hole and full-hole drilling models. Furthermore, to measure the bone temperature, full-hole drilling experiments were conducted by using some pre-inserted thermocouples on the sites with different radius and depth in the bone surrounding the drilling site, and the accuracy of the theoretical model was verified by the data measured by these thermocouples. The output of the revised theoretical model based on thermal imaging data was compared with the temperature data measured by the thermocouples. During the full-hole drilling process, the maximum deviation between the theoretical value and experimental data was about 2.5 °C, and the root mean square error was about 0–2 °C. The temperature variations during the entire drilling process were within a reasonable range. According to the full-hole drilling experiments with thermocouple measurements, the temperature values at different sites around the drill hole corresponded well with the data calculated by the theoretical model. The accuracy of the theoretical model could meet the temperature calculation requirements for robotic clinical drilling, thus it can provide doctors with corresponding suggestions during dental implant surgery, and also offer a basis for real-time temperature control in implant robot drilling.

Influence of cutting force on temperature, microcracks and chip morphology during rotary ultrasonic bone drilling: An in-vitro study

Temperature Field in Bone During Robotic Dental Implant Drilling: Theoretical Models and in Vitro Experiments

Ultrasonic-assisted drilling of cortical and cancellous bone in a comparative point of view

Mechanical and thermal damage in cortical bone drilling in vivo

Analysis of machining process and thermal conditions during vibration-assisted cortical bone drilling based on generated bone chip morphologies

Descriptive study of the longevity of dental implant surgery drills

Drilling force and temperature of bone under dry and physiological drilling conditions

Parametric Investigation on Different Bone Densities to avoid Thermal Necrosis during Bone Drilling Process

Thermal Evaluation of Bone Drilling: Assessing Drill Bits and Sequential Drilling

An in vitro study of thermal necrosis in ultrasonic-assisted drilling of bone

A Review of Surgical Bone Drilling and Drill Bit Heat Generation for Implantation

Temperature change in pig rib bone during implant site preparation by low-speed drilling

Microscopic Analysis and Evaluation of Thermal Elevation and Wear of Drills for Implant Site Preparation: An In Vitro Study

Analytical and experimental study of effective parameters on process temperature during cortical bone drilling

The influence of drill length and irrigation system on heat production during osteotomy preparation for dental implants: an ex vivo study

On the importance of precision in cortical bone drilling: Integrating experimental validation and computational modeling

Infrared Thermographic Evaluation of Temperature Modifications Induced during Implant Site Preparation with Steel vs. Zirconia Implant Drill

Assessment of Thermal Osteonecrosis during Bone Drilling Using a Three-Dimensional Finite Element Model

Investigation of transient machining in the cortical bone drilling process by conventional and axial vibration-assisted drilling methods

Effects of surgical drills on heat generation during bone drilling

A novel self-centring drill bit design for low-trauma bone drilling