Abstract:In this article, we present the design and analysis of an electrochemical circuit for measuring the concentrations of therapeutic drugs using structure-switching aptamers. Aptamers are single-stranded nucleic acids, whose sequence is selected to exhibit high affinity and specificity toward a molecular target, and change its conformation upon binding. This property, when coupled with a redox reporter and electrochemical detection, enables reagent-free biosensing with a subminute temporal resolution for in vivo therapeutic drug monitoring. Especially, we design a chronoamperometry (CA)-based electrochemical circuit that measures the direct changes in the electron transfer (ET) kinetics of a methylene blue reporter conjugated at the distal end of the aptamer. To overcome the high-frequency noise amplification issue when interfacing with a large-size (> 0.25 mm<sup>2</sup>) implantable electrode, we present a sample-and-hold (S/H) circuit technique in which the desired electrode potentials are held onto noiseless capacitors during the recording of the redox currents. This allows disconnecting the feedback amplifiers to avoid its noise injection while reducing the total power consumption. A prototype circuit implemented in 65-nm CMOS demonstrates a cell-capacitance-insensitive input-referred noise (IRN) current of 15.2 pA<sub>rms</sub> at a 2.5-kHz filtering bandwidth. We tested our system in human whole blood samples and measured the changes in the ET kinetics from the redox-labeled aptamers at different kanamycin concentrations. By employing principal component analysis (PCA) to compensate for the sampling errors, we report a molecular noise floor (at SNR = 1) of 3.1 $mu text{M}$ with sub-1-s acquisition time at 0.22-mW power consumption.

An Electrochemical CMOS Biosensor Array Using Phase-Only Modulation With 0.035% Phase Error And In-Pixel Averaging

Multiplexed Chemical Sensing CMOS Imager.

A Novel Structure of Laps Array for Cell-Based Biosensor

A Multimodal and Multifunctional CMOS Cellular Interfacing Array for Digital Physiology and Pathology Featuring an Ultra Dense Pixel Array and Reconfigurable Sampling Rate

A CMOS Pixelated Nanocapacitor Biosensor Platform for High-Frequency Impedance Spectroscopy and Imaging

A fully integrated CMOS nanoscale biosensor microarray.

High Density Cmos Electrode Array For High-Throughput And Automated Cell Counting

CMOS-Based Biosensor Arrays

A Biosensor-CMOS Platform and Integrated Readout Circuit in 0.18-μm CMOS Technology for Cancer Biomarker Detection

A Point of Care Electrochemical Impedance Spectroscopy Device

A Dual-Mode Large-Arrayed Cmos Isfet Sensor For Accurate And High-Throughput Ph Sensing In Biomedical Diagnosis

Amorphous Silicon Thin Film Transistor Biosensing System

CMOS-based On-Chip Electrochemical Sensor

Lab-on-Chip for Everyone: Introducing an Electronic-Photonic Platform for Multiparametric Biosensing Using Standard CMOS Processes

Super-Resolution Electrochemical Impedance Imaging with a 100 × 100 CMOS Sensor Array

A CMOS Multi-Sensor Array for High Accuracy On-Chip Bacterial Growth Monitoring

A 32×32 ISFET Array with In-Pixel Digitisation and Column-Wise TDC for Ultra-Fast Chemical Sensing

A Voltage-Assist 16-Channel Electrochemical Biosensor with Linearity Compensation

A Scalable CMOS Molecular Electronics Chip for Single-Molecule Biosensing

A High Dynamic Range Cmos Readout Chip for Electrochemical Sensors

Design and Analysis of a Sample-and-Hold CMOS Electrochemical Sensor for Aptamer-Based Therapeutic Drug Monitoring