Abstract:One of most enduring topics in the field of biosensors and bioelectronics is cell-based biosensors, which are able to convert cellular biological effects to electrical signals, via living cells. As the archetypal interface between a biological and an electronic system, the research and development of cell-based biosensors are essentially dependent on the combined knowledge of engineers, physicists, chemists and biologists. In recent years, the miniaturization and expanding applications of cell-based biosensors in biology, environment and medicine fields, have drawn extensive attention. Light addressable potentiometric sensor (LAPS) is a semiconductor device proposed by Hafeman in 1988, and it is now as commonly used as ISFET (Hafeman et al., 1988). LAPS indicates a heterostructure of silicon/silicon oxide/silicon nitride, excited by a modulated light source to obtain a photocurrent. The amplitude of this light induced photocurrent is sensitive to the surface potential and thus LAPS is able to detect the potential variation caused by an electrochemical even. Therefore, in principle, any event that results in the change of surface potential can be detected by LAPS, including the change of ion concentration (Parce et al., 1989), redox effect (Piras et al., 1996), etc. LAPS shows some advantages comparing to ISFET while constructing cell-based biosensor. The easier fabrication process of LAPS is fully compatible with the standard microelectronics facilities. The encapsulation of LAPS is much less critical since no metal contact is formed on the surface. Besides, the extremely flat surface makes it compatible to incorporate into very small volume chamber, which is important for small dose measurement. Therefore, LAPS seems promising for biomedical application. Due to the spatial resolving power, LAPS also has an advantage for array sensing application (Shimizu et al., 1994). Usually, no additional sensor structure is needed to realize the LAPS array sensing. In fact, LAPS is an integrated sensor itself, whose integration level is defined by the spatial resolution and the illuminating system. Thus, miniaturization with high integration level can be achieved. Many efforts have been drawn on the integration of LAPS (Men et al., 2005; Wang et al., 2005). Among these attempts, most are focused on the

CMOS-Based Biosensor Arrays

Multiplexed Chemical Sensing CMOS Imager.

Chip-based Waveguides for High-Sensitivity Biosensing and Super-Resolution Imaging

Cell-Based Biosensors and Bio-MEMS for Its New Applications

Cell-Based Biosensors Principles and Applications Introduction

Light Addressable Potentiometric Sensor As Cell-Based Biosensors for Biomedical Application

Cantilever-Based Biosensors in CMOS Technology

A Multimodal and Multifunctional CMOS Cellular Interfacing Array for Digital Physiology and Pathology Featuring an Ultra Dense Pixel Array and Reconfigurable Sampling Rate

An Electrochemical CMOS Biosensor Array Using Phase-Only Modulation With 0.035% Phase Error And In-Pixel Averaging

A Scalable CMOS Molecular Electronics Chip for Single-Molecule Biosensing

Commercialisation of CMOS integrated circuit technology in multi-electrode arrays for neuroscience and cell-based biosensors

A fully integrated CMOS nanoscale biosensor microarray.

Multisensor smart system on a chip

Complementary Metal-Oxide-Semiconductor-Based Magnetic and Optical Sensors for Life Science Applications

CMOS-based On-Chip Electrochemical Sensor

Lab-on-Chip for Everyone: Introducing an Electronic-Photonic Platform for Multiparametric Biosensing Using Standard CMOS Processes

A CMOS-Based Tactile Sensor for Continuous Blood Pressure Monitoring

CMOS Meets Bio

CMOS Point-of-Care Diagnostics Technologies: Recent Advances and Future Prospects

Recent Advances in CMOS Electrochemical Biosensor Design for Microbial Monitoring: Review and Design Methodology

Dual-Mode Sensing Chips for Wide-Range and High-Accuracy Biomarker Detection