Abstract:The glycerol generated as a by-product in the production of biodiesel could be used as a renewable raw material to economically promote the production process. The catalytic conversion of glycerol to a product with higher added value, such as glycerol carbonate, has attracted great interest in the chemical, pharmaceutical, and lithium battery industries, among others, due to its low toxicity, hydration capacity, and biodegradability. Layered-double hydroxide (LDH) materials, the precursors of the catalysts, were synthesized by a direct coprecipitation method to incorporate a third metal ion in addition to magnesium and aluminum ions. This method is the easiest regularly applied technique to design these low cost anionic nanoclay. The atomic percentage of Cu, Zn, or Ni incorporated was 15% of the Mg load in the material. The synthesis atomic ratio, (M 2+ +Mg 2+ )/Al 3+ had a constant value of 3, where M represents the transition metal incorporated. LDHs produced the corresponding mixed metal oxides by thermal decomposition. These materials have excellent properties for reactions catalyzed by the basic sites, high surface area, homogeneous cation dispersion, and thermal stability. The physicochemical material properties were characterized by XRD, N 2 sorption, MP-AES, TPD-CO 2 , SEM, and XPS. The mixed oxides were evaluated in the catalytic conversion of glycerol to glycerol carbonate. The addition of Cu, Ni, or Zn to the matrix of Mg and Al produced changes in its physicochemical properties and mostly in the catalytic activity. X-ray diffractograms of LDHs showed the typical characteristic structure of layers even with metallic ions of Cu, Ni, or Zn incorporated, because their ionic radii are similar to that of the Mg ion, 0.69, 0.73, and 0.74 Å, respectively. The obtained mixed oxides showed a high catalytic activity towards the conversion of glycerol to glycerol carbonate under mild reaction conditions, a 1:2 ratio of glycerol:ethylene carbonate and solvent free. Relative yields higher than 80% were obtained, attributable to an adequate distribution of basicity and textural parameters. The catalysts were used in successive reaction cycles without significant loss of activity.

Production of Lactic Acid via Catalytic Transfer Dehydrogenation of Glycerol Catalyzed by Base Metal Salt Ferrous Chloride and Its NNN Pincer-Iron Complexes

Highly efficient Ni-Mn/SiO<sub>2</sub> catalyst for the selective hydrogenation of biomass-derived levulinic acid to -valerolactone under mild conditions

Selective Production of gamma-Valerolactone and Valeric Acid in One-Pot Bifunctional Metal Catalysts

Heterogeneous Non‐noble Catalyst for Highly Selective Production of Linear α‐Olefins from Fatty Acids: A Discovery of NiFe/C

Oxidation of glycerol to a lactic, glycolic acid mixture using a Li, Ni, Mn, Co oxide catalyst and p-TsOH—SnCl2 catalyzed polymerization to poly(lactic-co-glycolic acid)

Zinc Glycerolate: an Unconventional Heterogeneous Catalyst for the Glycerolysis of Fatty Acids in Biodiesel Production

Sustainable production of bio-propionic acid: Facet-mediated C-O bond cleavage of Fe 3 O 4 nano-crystallites

An Efficient and Reusable Bimetallic Ni3Fe NPs@C Catalyst for Selective Hydrogenation of Biomass-Derived Levulinic Acid to Γ-Valerolactone

Selective Catalytic Dehydrogenative Oxidation of Bio-Polyols to Lactic Acid

Acceptorless dehydrogenation of glycerol catalysed by Ir(III) complexes with carbohydrate‐functionalised ligands: a sweet pathway to produce hydrogen and lactic acid

Mixed oxides from calcined layered double hydroxides for glycerol carbonate production to contribute to the biodiesel economy

Fe3O4-PDA-Lipase as Surface Functionalized Nano Biocatalyst for the Production of Biodiesel Using Waste Cooking Oil as Feedstock: Characterization and Process Optimization

Selective electrooxidation glycerol to lactic acid coupled with hydrogen production over a cooperative BiOx/Au catalyst

A new heterogeneous acid catalyst system for esterification of free fatty acids into methyl esters

Hydrodeoxygenation of Levulinic Acid to γ-Valerolactone over Mesoporous Silica-Supported Cu-Ni Composite Catalysts

Efficient Electrocatalytic Oxidation of Glycerol to Formate Coupled with Nitrate Reduction over Cu-Doped NiCo Alloy Supported on Nickel Foam

Selective Electrooxidation of Crude Glycerol to Lactic Acid Coupled With Hydrogen Production at Industrially‐Relevant Current Density

Robust Iridium Coordination Polymers: Highly Selective, Efficient, and Recyclable Catalysts for Oxidative Conversion of Glycerol to Potassium Lactate with Dihydrogen Liberation

Catalytic production of biodiesel from esterification of lauric acid over a solid acid hybrid

Glycerol carbonate synthesis via transesterification of enriched glycerol and dimethyl carbonate using a Li-incorporated MCM-41 framework

Oriented Conversion of a LA/HMF Mixture to GVL and FDCA in a Biphasic Solvent over a Ru Single-Atom/Nanoparticle Dual-Site Catalyst